Windows 10: Getting BSOD every first boot of the day or after a while

I get BSOD every time I boot up my PC after a day or having turned off for a while. But after some looping, I can access windows and I don't get BSOD even after restarting during that session. After using WhoCrashed on the dump files I had, I got the following:Windows version:Windows 11, 10.0, version 2009, build: 26100 x64Windows dir:C:\WINDOWSHardware:ASUS TUF Gaming A15 FA506NC_FA506NC, ASUSTeK COMPUTER INC., FA506NCCPU:AuthenticAMD AMD Ryzen 5 7535HS with Radeon Graphics 8664, level: 25Processor count:12 logical processors, active mask: 4095RAM:15690.8MB Crash Dump AnalysisCrash dumps ar

:)

 

ughhh! BSOD on boot

I guess my computer BSOD on boot right before getting to windows. not sure what the problem is though, everything is stable.

It gave me a list of two files in windows that could have caused the problems

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.

 

laptop doesnt boot automatically

This is what happened.

1. Did a repair install and later disabled hibertnate in CMD.
2. Enabled legacy option ROM in BIOS.
3. After a few times startup ( i used the system in such mode for 5 days), changed boot option back to default.
4. Vola!! It boots automatically to win10 without any keypress. Tested it with many starts to confirm the same.
5. Re-enabled hibernate option using CMD and later selected Fast Startup.
6. System booted normally, without the need for any keypress.

I do not know exactly whether such steps resolved the problem or what else happened, hence cannot suggest above steps.

Many thanks to all members who helped to troubleshoot problems.