Windows 10: Getting BSODs all the time

Hi! Recently I've made a fresh install of Windows on my PC, and suddenly I'm having a lot of BSODs out of the blue.I reverted my BIOS settings to default, got most of my drives updated, ran a bunch of prompts commands, either in OS or in recovery mode. None seems to fix it.I suspect my motherboard may be the issue or my memories are going defective, as both are very old.To get a more precise analysis, I'm linking my minidump file, so if someone can give it a closer look and help me figure out what's wrong: https://1drv.ms/u/c/1c407f3e05f21ea9/Eb3Thp7CiVZLrqT76O7F6bQBGjqWEDav08h7J4yz47_mHw?e=e5

:)

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.

 

Cheap Photo box that will get the job done

WEll i took on this project for PP hes a hardware reviewer and wants to get the professional looking pics for the Pc parts

Materials:

• Big cardboard box

• a razor

• white material 3 yards

• cone lights

• stapler

• medical tape

• pvc pipe about 6 inches longer than your box

• white paint any cheap finger paint would work

the project I'm guessing will cost me $30 if it works out properly
I will post pictures and step by step as i do it