Windows 10: Getting BSODs when I close videogames, sometimes

Hello everyone, it's the first time I'm writing and posting here.In recent weeks, sometimes, I have been getting BSODs just right after closing videogames. It's any videogame really, the BSODs are not tied to a specific one.This is the OneDrive link to the minidumps that I'm pretty sure were created after each BSODs: minidumpsI'll post my system spec here, I've recently bought a new CPU and a new GPU but for the first few weeks everything was running smoothly, in more recent times I've had BSODs. I've ran memtest86 and found 0 errors on my RAM, I've tried to repair windows without formatting

:)

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.

 

Cheap Photo box that will get the job done

WEll i took on this project for PP hes a hardware reviewer and wants to get the professional looking pics for the Pc parts

Materials:

• Big cardboard box

• a razor

• white material 3 yards

• cone lights

• stapler

• medical tape

• pvc pipe about 6 inches longer than your box

• white paint any cheap finger paint would work

the project I'm guessing will cost me $30 if it works out properly
I will post pictures and step by step as i do it