Windows 10: Getting continuous BSOD

I’m getting continuous BSOD with error code 0xc000021a. With Windows 10. The few times I was able to get to repair screens I ran scans and one time I had a partition error that was allegedly fixed. Hey on following scans there was no errors found in my hardware.

Most of the threads I’ve found through google have related it to Windows 10.

I went to reset my PC once and it informed me that my password was incorrect (it wasn’t) idk if two factor authentication plays a part in that. I have not been able to get back to that screen.

One time I was able to get to my BIOS but to be honest I had no idea where to go from there to fix my problem.

I have seen some discussions talking about putting windows 10 on a drive and re downloading it onto my PC that way, but I have no way off doing that as of now.

At this point I’ve come to terms with the fact that I will have to re download everything, but no with the cycling blue screen, and telling me my password is incorrect, I have no idea how to even get to the point of just resetting my PC.

Any and all help will be so greatly appreciated.

submitted by /u/Mikew2q
[link] [comments]

:)

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.

 

Getting continuous BSOD's on startup

Original Title: Windows 10 BSOD

I get continuous BSOD's on startup and on occasion the BSOD will happen after boot sometime. I have included a link to a zip file containing a minidump, memorydump and system info. Please help!

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.