Windows 10: Getting multiple BSOD

Hi all,As the title mentions I've being getting a lot of BSOD.The link to the available mini dumps is here.I've already installed WindowsRan the SFC and DISM commands, also ran memory and ssd diagnostics.Can anyone help?Thanks in advance.

:)

 

Getting BSOD 0x124 error

Ignore what everone said here.

0x124 BSOD is usually related to VCCIO (VTT), run Prime95 version 26.6 with custom sizes of 512K to 640K with 50% of your memory for at least 8 hours.

If you get a 0x124 BSOD, increase VCCIO voltage by small steps, run Prime95 again until your stable.

If you pass Prime95 512K to 640K without a BSOD, then its Vcore too low. I'd suggest running IntelBurnTest with 80% of your memory to verify stability (8 to 12 hours).

Oh, and yeah, if this problem appeared all of the sudden, the reason is CPU degradation, you can prevent it by enabling C-States or adjust your overclock to use lower voltages.

 

Getting multiple different BSOD crashes tried MANY things

I cannot do the last three steps because they take too long and my computer BSOD's every time.

Images:














All of the rows in the health tab said ok.

New crash dmp files.
Dump files.

 

HP laptop - multiple BSODs

I have an HP Pavilion 15-cs0021na, (Intel i3, 8GB, 128GB SSD) running Windows 10 Home, which exhibits the following characteristics:

• On startup, occasionally completes boot, but within 5 minutes, BSODs. with a random error, e.g. Page Fault, IRQL not equal, Memory Management and so on.
• Repeated attempts to reboot then fail with more random BSODs
• Rarely, it will attempt a Startup Repair – which will invariably fail with another BSOD.
• Wiping the hard disk and attempting to install a clean version of the OS (downloaded from Microsoft using Media Creation Tool to USB stick) will get a little way into the process, then fail with BSOD as above.

What I’ve done:

• Attempted clean install as above.
• Run multiple hardware tests on Memory and SSD - HP’s built-in tests, Memtest86, Seagate disk tools. All tests pass with no errors.
• Updated BIOS from Insyde F.04 to F.22 (HP supplied).
• Repeated clean install, same result.

I have now run out of ideas, and am at a loss to understand what is causing these errors. How are BSODs generated if no Windows installation is present? Is it likely that a hardware component other than RAM or the SSD is causing these?

Any and all suggestions will be much appreciated.