Windows 10: Good morning. I need to change the windows boot to "DISK 1" because I have to remove "disk...

submitted by /u/victorsnk676
[link] [comments]

:)

 

Can't safely remove external disk

In reference to the steps of your suggestions:

• The issue is specific to the particular disk and it started after I've used the disk to save the System image backup (created with the Control Panel > File History tool).
• I didn't disable any windows Service. I'm just wondering if there is any to disable.
• Safe boot with networking, or clean boot doesn't resolve the issue.

Thank you.

 

Windows wont boot; stuck at chk disk

I ran a chk disk the morning, its ran through and rebooted was going normal shown windows splash screen then right back too chk disk again i press any key to skip chk disk and it then reboots....same process...tried F8 doesn't boot, tried last known config doesn't boot,unfortunately i don't have a cd to boot from. I really don't know what to do and need information from this drive. currently I'm running a start-up repair. If this doesn't work what ells could i try?? it shows the windows splash screen then goes right to a chk disk i have ran it twice already. why wont it just boot*Bang Head :banghead:

I have windows 7 ultimate.

thanks

 

Disk management console view is not up-to-date

i dont know how to fix your disk management, but i can fix your partition problems...




open up Command Prompt with admin rights. (Right click, run as admin)


enter in
DISKPART
list disk

then find the Disk number for your Raid array... lets call it number 7 ( you can tell what disk is what by the total size)
type in

Select Disk 7
List Partition (will give you a list of all the partitions..)
Select Partition 1 (im assuming you only have 1 partition on Disk 7) repeat this step if you have more partitions.
ASSIGN


that should get the array up and running ready to use.


EDITED.

any problems, post back ^^


Still EDITING *Stick Out Tongue

side question, have you tried restarting the PC?