Windows 10: Hard disk problem

My hard disk get converted from basic to dynamic. How to convert a hard disk from Dynamic to Basic without loss of data?

I tried too many apps to fix it, but i failed..

please suggest me any better solution..

:)

 

External Hard disk contents are not visible.

Hi Pranoti,

For us to narrow down your concern with your external hard disk, we would like to know the following:

• Were there any changes made on your computer prior to the issue (e.g., updates, software installation)?
• To make sure that we have not missed on anything, what troubleshooting steps have you done so far?
• Do you hear any clicking sound when connecting your hard disk?

In the meantime, we suggest that you update all your device driver.

We look forward to your response.

 

hard disk drive problem

i have a western digital 120 gb ide hard drive ( there was still 25 gb free space ) and everything was running fine until i decided to update windows xp home edition service pack 1 to service pack 2. I updated the windows and after the updating was done it asked me to restart the computer so i restarted the computer and it was normal then the windows would not start up. i turned off the computer and then turned it back on, everything gets on normally but it gets stock at where it says windows xp, it just stays there forever therefore i dont get to my desktop. Any idea what might be causing the problem?

I have an old hard disk drive which im not using and it has 10 gb space. Can i plug it to my system and run the windows from that and still be able use my other hard disk too so i can uninstall the service pack 2 from my hard disk.

Waiting for your suggestions!

Thank you for your time !

 

Disk management console view is not up-to-date

i dont know how to fix your disk management, but i can fix your partition problems...




open up Command Prompt with admin rights. (Right click, run as admin)


enter in
DISKPART
list disk

then find the Disk number for your Raid array... lets call it number 7 ( you can tell what disk is what by the total size)
type in

Select Disk 7
List Partition (will give you a list of all the partitions..)
Select Partition 1 (im assuming you only have 1 partition on Disk 7) repeat this step if you have more partitions.
ASSIGN


that should get the array up and running ready to use.


EDITED.

any problems, post back ^^


Still EDITING *Stick Out Tongue

side question, have you tried restarting the PC?