Windows 10: Have no OS and i cant install one because my ssd is unallocated help

I recently wanted to reset my PC so i went ahead and created a bootable usb with RUFUS and used a windows10.iso file burnt into the usb before i began on installing it i went on CMD and cleaned my C drive then i went to install new OS but after sometime passed it gave an error in the middle of the installation saying windows could not install required files or something like that and i clicked OK it sent me back to begin setup where i choose which partition i want to install windows in but when i tried to install it on C i saw that it was unallocated and had 0 bytes in it when i checked it on

:)

 

Install Diablo 3 on Linux

Just install PlayOnLinux? Why did they make step 2 and 3 of this "tutorial"?

Anyway, looking at the supported software list for PlayOnLinux, D3 is a step in the right direction. Lack of gaming is a factor for a lot of people when deciding on an OS, if more recent games get ported it may help migrate them to their preferred choice.

 

No Boot, Drives Not detected, Can't Load Win10 Pleses Help!

Until the BIOS sees your M.2, there's nothing you can do. It does not matter if the M.2 is unformatted/unallocated, the BIOS should see it.

1. Suggest that you take the M.2 out, clean all the contacts and re-seat it and hope this is the case.
2. If step one fails. Connect your 250GB SSD back in using one of the SATA port to see if the BIOS recognize it. If it doen't, then it might be something wrong with the MB, if it does then boot up the Windows Installation USB, run diskpart, shrink it at least 40GB then create a partition, Leave it unallocated then install Windows there.

Also try to re-seat all other components such as Memory, Video card etc...

 

URGENT HELP NEEDED! HDD suddenly became blank!

Hey there, @Shamonto Hasan Easha!

I'd try re-plugging the hard drive and checking if the cable is damaged. I'd also suggest to try plugging the drive in another computer and see if it gets recognized properly there. Is it a IDE or SATA drive you're using?
If the drive is unallocated, this means that the partition has been lost after the power went down.
Check out this thread for more ideas on how to solve the issue. There are some detailed steps there that might be useful for you:
http://superuser.com/questions/5442...n-on-ssd-suddenly-became-unallocated-disk-spa

Hope this helped.
SuperSoph_WD