Windows 10: Having BSOD with different causes

I'll send here the link for my minidump files:https://drive.google.com/drive/folders/1Bp7NKGyWxi1tZDJ7zLNYCQtFxLMwNXiP?usp=sharingIt started after one year I replaced my SSD because it already has problemssaid my technicianMy laptop is a helios 300 2019 versionph315-52Using 2 ssd and 1 hdd>even tho my technician said that my former ssdlocal disk C is already dead and malfunctioning, I still continued using it for my fileslocal disk e, because using Crystal disk info, it stated that it's health is 98 percent and didnt had any major issues for a year until nowI shared this info becaus

:)

 

7 different BSoD

Hey guys,

I have a serious problem. I make it as short as possible:

• system runs 100 % fine with the 10.12
• updatet to Catalyst 11.1 -> BSoD
• updatet to 11.1 Hotfix -> BSoD
• rollback to 10.12 -> BSoD
• removed ALL AMD files manually, installed 10.12 -> BSoD

• Temps are fine
• no sfc /scannow errors
• no chkdsk errors
• Prime, Furmark all fine
• regardless what driver I install -> BSoD
• I did no hw changes, no OC

Here are my BSoDs I receive:

• 0x0000010e
• 0x1000007e
• 0x0000007e
• 0x0000004e
• 0x0000003b
• dxgmms1.sys
• PFN_LIST_CORRUPT

They all refer to the GPU of course ...

From now on I receive a BSoD every time I try to play a game (especially BC2 and SC II) even if I completely remove the old driver and make a clean install.
Apparently the 11.1 damaged my system irreparable.

Any advice or info would be very much appreciated *Smile

 

BSOD Hardware Caused???

Thanks for all the replys and support!!! *Toast :toast:
OK I put in a different battery pack....hope it doesnt BSOD on me again...
I checked all the things listed above and none was the case

 

Multiple BSODS with different errors, caused by ntoskrnl.exe

Wow thats a lot of usual causes!

Just to clarify / remove some things of that list, as mentioned the RAM has passed memtest multiple times, none of my hardware is OC'd, BIOS is fully up to date.

As far as I'm aware this is because its the single ram speed, and with it being DDR its 800*2=1600, I could be mistaken though?

As for the slots basically I was having BSOD's whenever any module was installed in one of the channels, so I had to move both modules over to the other channel, and this seemed to fix it, however I can move them back around to see what happens.

As for the memory I could have sworn I saw it on the supported list a while ago, ill check with the vendor of my PC.

Thanks for all the help

So whats the next step?