Windows 10: Having problems with laptop booting

Somehow I accidentally started the windows 11 update. As soon as I realized it I tried to stop it. I couldn't so I panicked and turned the laptop off. When I turned it back on it I was prompted to do Lenavo updates, so I did those, but now my laptop isn't booting up completely. Don't know if it's from turning off my laptop without letting the windows 11 finish updating... or from doing my Lenavo updates. Assistance very appreciated!

:)

 

laptop doesnt boot automatically

This is what happened.

1. Did a repair install and later disabled hibertnate in CMD.
2. Enabled legacy option ROM in BIOS.
3. After a few times startup ( i used the system in such mode for 5 days), changed boot option back to default.
4. Vola!! It boots automatically to win10 without any keypress. Tested it with many starts to confirm the same.
5. Re-enabled hibernate option using CMD and later selected Fast Startup.
6. System booted normally, without the need for any keypress.

I do not know exactly whether such steps resolved the problem or what else happened, hence cannot suggest above steps.

Many thanks to all members who helped to troubleshoot problems.

 

HP Laptop Boot Loop

I am encountering a boot loop problem with my HP laptop. Upon startup, it shows the HP logo and loading dots for about 11 seconds, then goes to a blank screen for approximately a minute before automatically restarting. The power button does not turn off during this cycle.

Troubleshooting Steps Taken:

• Tried hard reset and accessing BIOS/UEFI settings.
  
• Unable to boot into Safe Mode or recovery environment.
  

please see here the recorded video demonstrating the boot loop behavior for reference.

Any advice, troubleshooting steps, or insights into what might be causing this problem would be greatly appreciated.

Thank you in advance for your help and suggestions.

 

Windows 10 1709 System Restore problems...

That seems to be an attempt at Option 2 in the tutorial, which requires you to
a. Boot to a command prompt (Did you?)
b. You then seem to be mixing steps 3,4 and 5, thus your command is incorrect.

I suggest Option 1 is easier.

If you still have problems, please repost listing each specific step and saying which option from the tutorial you are using. Thanks.