Windows 10: Hello I have a 5k resolution mac and I’m running boot camp on it, but the windows one only...

It’s on 4K and I can’t go higher than that on it.

submitted by /u/Shaggytit
[link] [comments]

:)

 

Bluetooth is not working with Boot Camp after upgrading to Windows 10

Hi,

To enable your Bluetooth, run the Boot Camp Assistant from the Utilities folder on your Mac and install the support software, which includes the latest drivers you need for Bluetooth.

• 
  Check for software updates to make sure OS X, your Mac firmware, and Boot Camp Assistant are
  up to date.
  
• 
  Run Boot Camp Assistant and install the support software, which includes the latest Boot Camp drivers you need for Bluetooth.
  You can find step-by-step directions at Apple’s Support Site here.
  

After reinstalling the drivers, all paired devices from Windows 8.1 should still be paired and usable.

 

Mac OS boot camp

If you are running macOS Sierra 10.12.5 or later, Windows 10 1703 or later should be sufficient.

All you need to do is download the ISO file:

Download Windows 10

Press Command key + Space bar

Type: Boot Camp

or Open the Finder > Applications > Utilities > Boot Camp

Launch Boot Camp

Click Continue

Click Browse

Select the ISO file you just downloaded

Resize the partition - I recommend about 40 to 50 GBs or more when dual booting with Windows. See the following article for more information about deciding on space:

How to Install Windows 10 On Mac OS X Using Boot Camp

Click Install

Wait while partitions the disk

Downloads Windows Support software

Your Mac will automatically restart and Boot into Windows 10 setup.

Remember to choose the partition during setup named BOOTCAMP.

You should be good to go.

 

MacBook Pro running Windows 10 boot camp with Thunderbolt 3 and LG Ultrafine 5k display not working

I have a 2017 Macbook Pro with Thunderbolt 3 running Windows 10 Professional most up to date version in Boot Camp environment ("bare metal" not a VM)

I have an LG Ultrafine 5k display connected with a Thunderbolt 3 cable.

I can not get the display to work correctly in Windows 10 (works fine on Mac OS side)

When plugged in, the display will flicker a lot and I continually get errors about "USB device not recognized" over and over, as if the display is being constantly plugged in and out.

Windows Event Viewer does not show any errors with GPU or graphics drivers.

Thanks!