Windows 10: Hello I need to reset my pc, but having trouble

so I clicked reset and redownload windows through local and had it wipe everything and have tried doing it 3 times now, each try screen goes dark so I waited up to 8 hours and nothing would happen so I would just power off and try again but nothing is working and I need to sell this pc

:)

 

trouble with windows hello

Hello Alagu,

Thank you for reaching out to us. Windows 10 may have encountered a corrupted component that caused this Windows Hello issue. For us to help you with this, kindly answer the following questions:

• Have you made any recent changes to your computer prior to this issue?
• We'd like to clarify the error message, is it Device is not compatible whenever you try to sign in?
• What is the current build and version of your Windows 10? To check type in
  winver on the search bar and press Enter.

Meanwhile, we suggest that you run the Windows Troubleshooter for devices and hardware through this

link and click the section that says Find and fix problems with devices and hardware.
We also recommend that you reset the Facial Recognition and Fingerprint options. Kindly follow the steps below:

• Press Windows key + I to open
  Settings.
• Click Accounts and select
  Sign-In options.
• Locate Fingerprint or
  Facial Recognition options and click
  Remove under them.
• After that, click Get Started and follow the on-screen instructions to reset Fingerprint and Facial Recognition.
• Reboot your PC to apply the changes.

We'll be waiting for your reply.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Unable to reset the pc

Hello,

If you are having that message while trying to reset your computer, We suggest you to create an installation media for Windows 10 using Media
Creation Tool and perform a Reset.

Once the installation media is created, follow the steps below:

• Insert the installation media you created, and then restart your PC.
• On the Install Windows screen, select Repair your computer.
• On the Choose an option screen, select Troubleshoot. From there, you can use Safe Mode. Select
  Advanced Options >Reset This PC>Remove everything.
• After the reset is complete, check for status.

Give us an update on what happens.