Windows 10: Help Analyzing Minidump files with Driver Verifier turned on

Hello, I have recently upgraded by PC with a new MSI B550 Gaming GEN3 Gaming Motherboard, a Ryzen 5 3600, and Corsair Vengeance LPX 16GB 2x8GB DDR4, as well as upgrading to Windows 11. I have reinstalled the chipset drivers multiple times, and I still keep getting BSOD. I have also tried one RAM stick at a time, memtest, and different memory tests to rule out a possible RAM issue. The analysis of the WinDBG minidump files makes me think this is a leftover driver configured for Windows 10, or a previous installation of Windows as its the OSNAME. I had driver verifier turned on, and have left

:)

 

win11 help analyze Minidump thankyou

Hi aywm

Your minidump files once again just indicate memory (RAM) corruption no specific driver is listed

1

The best option is to download the widely available free utility MemTest86, then run a full 4 pass scan with that to test your RAM for physical errors

2

If no RAM errors are found, to try to force Windows 10 show any faulting drivers, the best option would be to turn on Driver Verifier, let your PC crash 3 times, then you must turn off Driver Verifier, and finally, upload any newly created minidump files

https://answers.microsoft.com/en-us/windows/for...

 

Multiple BSODS - Help Analyzing Minidumps

Hi, I am Dave, I will help you with this.

Your minidump files just indicate memory (RAM) corruption no specific driver is listed

To try to force Windows 11 show any faulting drivers, the best option would be to turn on Driver Verifier, let your PC crash 3 times, then you must turn off Driver Verifier, and finally, upload any newly created minidump files

Before you run Driver Verifier, please create a new System Restore Point

https://answers.microsoft.com/en-us/windows/for...

-----------------------------------------

Note, if you have any difficulty getting into Windows with Driver Verifier enabled:

Start your PC, just as Windows attempts to load (spinning dots), press and hold Power Button for 5 - 10 seconds to perform a Hard Shut Down

Do this twice

On the third start Windows will boot into the Recovery Environment and from there you can access System Repair, Safe Mode, Command Prompt... etc.

Go to Troubleshoot - Advanced Option - Startup Settings and click Restart

Upon restart, press 4 to enter Safe Mode

Open Command Prompt as Administrator and run these two commands, then restart your PC.

verifier /reset

verifier /bootmode resetonbootfail

 

Driver malfunctioning. Please help me analyze dmp from Driver Verifier.

Pretty much topic.

Some driver is causing consistent crashes. Verifier detects issues already during bootup. I'm rolling back my graphics driver to see if that is the issue. I'd like some help analyzing the dmp files in the meanwhile.

Minidumps:

Microsoft OneDrive