Windows 10: HELP - Why is windows update trying to install Insyde - System - 1.0.0.8 BIOS?

Windows update shows it's pending a restart to install "Insyde - System - 1.0.0.8."It appears to be a Unified Extensible Firmware Interface UEFI BIOS - but it is NOT the BIOS for my laptop!I did not ask windows update to do this, it just automatically installed it and the first I knew about it was when I saw "pending restart."I have run full scans with McAfee & Malwarebytes and neither detect a virus/malware, nor does Windows defender quick scan.The laptop manufacturer Sager confirm it is NOT the right BIOS and if installed will "brick" my laptop.How do I make it stop? How do I roll ba

:)

 

Raid 0 help

Hi all, I've followed the IRST raid installation directions and I have created myself a Raid 0 volume. Rapid storage confirms my successful migration from a system disc to a raid 0 array. I'm also able to select it as my boot device in BIOS, but what I don't understand is why it is not listed in my Drives under my computer

In fact, my computer still lists my original C: drive with the original capacity. I feel as if I've miss an important step here and I'm unsure how to proceed.

 

System Reserved Partition on Disk 1 not Disk 0

The results were the same as before: Windows is installed in a single 477 GB partition on Disk 0 and the System Reserved is in a 500 MB partition on Drive 1. The rest of Drive 1 is unallocated. This is identical to the configuration I had when I asked the
question.

The Media Creation Tool used to created the install ISO DVD is v. 10.0.14393 downloaded on 12/13/2016.

I followed your instructions:

• I selected Drive 0 and deleted the existing Windows partition.
• I clicked New and Apply. Windows then formatted Drive 0 as a single primary partition.
• The existing System Reserved partition was still on Drive 1.
• So I deleted the System Reserved partition on Drive 1 and the just created Primary partition on Drive 0
• I then selected Drive 0 and clicked New and Apply again. Same result a single Primary partition on Drive 0. Drive 1 was left unallocated.
• Upon completion of the install
  • Windows occupies about 15 GB in the only partition on Drive 0
  • The 500 MB System Reserved partition was placed on Drive 1
  • The rest of Drive 1 is unallocated.

How can I get the System Reserved partition to be placed as the Partition 1 on Drive 0 with Windows installed in Partition 2?

Thanks.

Bill

 

Raid 0 help

You need to resize your NTFS partition. Run (Super + R; the run dialog box) and execute "diskmgmt.msc". You'll see that your RAID-0 is only partitioned to half of the array's size. Converting a disk to RAID doesn't do anything to the size of your partitions.