Windows 10: Help with resetting my laptop

hello, i recently encountered a problem when trying to reset my laptop. when it told me that i did not have recovery environment.after doing some digging, i went into CMD to execute reagentc /enable command but they told me that the The Windows RE image was not found.more digging, i found that my recovery folder had no winre.wim file.more digging, i tried using windows 10 setup to get media creation, but apparently "your PC can not run windows 10 while i am running windows 10more digging, sfc command showed no problemsand now i am stumped.please help me as i am quite worried

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Need help projecting PC to laptop

That seems a very old version of Connect. What version of Windows are you running on the laptop? Build 17763 suggests it is version 1809. What version are you running on the Desktop?


You could try resetting Connect. Click on Start and type 'connect' then select 'App settings' from the list on the right.

 

help to remote connect

not sure how to use both programs u 2 suggested, i need more helpful steps thanks