Windows 10: Hi! guys i was trying to install the following feature using Dism on a offline image and...

C:\Windows\system32>Dism /Online /enable-feature /FeatureName:NetFX3 /All /LimitAccess Deployment Image Servicing and Management tool Version: 10.0.16299.15 Image Version: 10.0.16299.15 Enabling features [==========================100.0%==========================] Error: 0x800f081f The source files could not be found. Use the "Source" option to specify the location of the files that are required to restore the feature. For more information on specifying a source location, see http://go.microsoft.com/fwlink/?LinkId=243077.

:)

 

DISM - Add or Remove Drivers on an Offline Image


Ah I thought you might be doing the DISM/drivers one.

It is good info and I use parts of this frequently when I'm reinstalling on my old hardware and need to manually add drivers.

I would suggest DISM /Get-Drivers as an alternate to the Powershell step in 2.2 - the table format is quite useful I find.

One method of applying the drivers I tried which seems to work (not sure how valid it is) when clean-installing a machine as a one-off:

1. Export drivers as per Step 2
2. Use DISM /Get-Drivers to show which driver is which, and copy only the ones I know are problematic to a subfolder, and add this subfolder to a bootable Windows 10 Setup USB
3. Boot Windows 10 Setup from the USB
4. Open a command prompt with Shift F10, type command 'wpeutil shutdown' but don't press enter. Instead, Alt-Tab back to Setup
5. Follow the normal clean install process, delete partitions and let it install the relevant edition
6. When it says Restarting in a few seconds, quickly Alt-Tab to the command prompt and press enter, to stop it restarting but shut down instead
7. Boot again from the USB, go straight into Shift-F10, and use DISM /add-driver to add relevant drivers to the offline Windows drive as per Step 4
8. wpeutil shutdown again, and let it restart this time, so that Windows boots and finishes configuring itself with the new drivers available to it.

I found it easier than Mounting the image and also means I don't change the .WIM so I can use that on other hardware without fear of non-standard (and probably quite old) drivers getting in the way .

Although in some cases I could install and change it once Windows is up and running , one of 1709's default drivers causes a BSOD during installation itself, if I don't add the alternative manually using the above technique before it gets to that point.

But it's not a technique I've seen anywhere else so I'm probably bending the rules somewhere. *Wink

 

DISM Offline mode - Install Feature package/source/Image - Server 2016

Disclaimer: Win10 sucks.

My question:
Where do I get DISM packages to install server 2016 features offline?

I need the Source/Package/Image for a specific feature in Server 2016. I can't figure out where to obtain this data.

Seems to me it might be the Server 2016 ISO?

I need to do this:
How To Backup Windows Server 2016

I need to use this:
How to Install Windows Features Offline Using DISM? - TECHNIG

Insight:
https://docs.microsoft.com/en-us/win...res-using-dism

 

DISM - Parameter "Cleanup-Image" is not known (error 87)

Hello Eric,

To troubleshoot your concern, we suggest that you run DISM Restore Health command. Refer to the steps provided below:

• Open Command Prompt (Administrator).
• Type the following command:

DISM /Online /Cleanup-Image /RestoreHealth

3. Press Enter.

Let us know how it goes.

Thank you.