Windows 10: HIDCLASS.SYS BSOD

Hello,Recently I've been receiving multiple BSODs with errors pointing to driver failures. I've ran Driver Verifier and allowed 3 BSODs under it and all three of those dmp files featured HIDCLASS.sys and I am wondering if anyone could point out to me what that is and how it is causing these crashes.For analysis of this file, run !analyze -vnt!KeBugCheckEx:fffff803`26e3f250 48894c2408 mov qword ptr [rsp+8],rcx ss:0018:fffff483`347bdbb0=000000000000007e8: kd> !analyze -v********************************************************************************

:)

 

BSOD hidclass with driver verifier

Hi Doc_Samson,



Thank you for writing to Microsoft Community Forums.



I understand that you receive Blue Screen error with hidclass.sys. In order to get to the root cause of the issue, we will need the Dump files, so that we can analyze them and assist you accordingly. I have sent a private message to you, please share
the Dump files over the private message.



To access Private Message click on your Profile on the top right corner, then click on the ellipses, and select
View Private Messages.



However, the hidclass.sys is a driver file for Human Interface Devices, which are basically, keyboard/mouse or gaming controllers. I would suggest you to disconnect all the external devices and see if that helps.



I would suggest you to refer the steps mentioned below and see if that helps:



Method 1: Update drivers



I suggest you to update the drivers on the computer, to make sure that all the drivers are up to date including Keyboard, Mouse, USB and HID Drivers. In addition, you may also update the chipset drivers from the computer manufacturer’s websites. Kindly
refer the article
Update drivers in Windows 10.



Method 2: Check hard disk for errors



I would suggest you to run chkdsk utility to check any errors in the hard drive. Refer the steps mentioned below:

1. Type command prompt in the search bar on the
   Taskbar.
   
2. Right click on the command prompt icon and select
   Run as administrator.
   
3. Now, paste the following command and hit Enter: chkdsk/f C:
   
4. Select Yes and restart the computer.
   

Note: While performing chkdsk on the hard drive if any bad sectors are found on the hard drive when chkdsk tries to repair that sector if any data available on that might be lost



Method 3: Windows Memory Diagnostic



You can also run Memory Diagnostic on the computer to check for any memory corruption errors. Follow the steps mentioned below:

1. Press Windows key + R, to open
   Run dialog box.
   
2. Type mdsched and click on
   OK.
   
3. Click on Restart now and check for problems.
   

You may want to refer the troubleshooting steps mentioned in the article

Troubleshoot blue screen errors.



You can also refer the suggestions provided by auggy replied on May 15, 2018 in the thread

BSOD Hidclass.sys.



Let us know how it goes.



Regards,

Nikhar Khare

Microsoft Community - Moderator

 

dxgmms2.sys BSOD

Hello,

A while back, my computer lost power while it was installing windows updates. Since then, I've had BSODs every couple days, with various errors pointing to a driver error. These were annoying, but manageable. I tried a few basic troubleshooting steps, like
using a removal tool for my graphics card drivers and reinstalling, but I didn't do much else.

The last couple days, the BSOD rate has ramped up, and I started seeing "dxgmms2.sys" get listed in the BSODs, which is relatively new.

I followed the instructions
here.

And here are my dmp files resulting from that:
https://1drv.ms/u/s!Au4wk9mJt6sJgcFgkEXA4rOFod4-cg?e=wIzEMq

Thanks.

 

7 different BSoD

Hey guys,

I have a serious problem. I make it as short as possible:

• system runs 100 % fine with the 10.12
• updatet to Catalyst 11.1 -> BSoD
• updatet to 11.1 Hotfix -> BSoD
• rollback to 10.12 -> BSoD
• removed ALL AMD files manually, installed 10.12 -> BSoD

• Temps are fine
• no sfc /scannow errors
• no chkdsk errors
• Prime, Furmark all fine
• regardless what driver I install -> BSoD
• I did no hw changes, no OC

Here are my BSoDs I receive:

• 0x0000010e
• 0x1000007e
• 0x0000007e
• 0x0000004e
• 0x0000003b
• dxgmms1.sys
• PFN_LIST_CORRUPT

They all refer to the GPU of course ...

From now on I receive a BSoD every time I try to play a game (especially BC2 and SC II) even if I completely remove the old driver and make a clean install.
Apparently the 11.1 damaged my system irreparable.

Any advice or info would be very much appreciated *Smile