Windows 10: Hoping for some helpful insight on technical issue

I have been trying to install on my Dell laptop an HP Desk Jet2852E and can not get it to install the printer it only wants to install the scanner program. My computer told me it needed a "WIA Driver" from the manufacturer... I had HP tech support on the phone for 2 hours trying to help me and then when they were unable to help me they passed me off to a different tech that kept uninstalling and reinstalling over and over again for 6 hours.....Still unable to print from my laptop. Now when I scan for a driver it just says "Driver unavailable". I also went on Dell's website to see if

:)

 

Sticky Notes "Insights" not working with handwriting

Hi ManuelGarces,



Thank you for writing to Microsoft Community Forums.

1. Have you tried to check the settings on the Sticky Note App if the
   Enable Insights is off?
   
2. Since when are you facing this issue?
   
   
   

I suggest you to follow the below steps, and check if that helps.



Method1: Try enable insights in Sticky notes.

1. Open the Sticky Notes app.
2. Click/tap on the 3 dots menu button, and click/tap on Settings.
3. Click/tap on Enable insights to toggle to disable (uncheck) or enable (check) it

Method 2: Fix problem with apps.



I suggest you to follow this article on
Fix problems with apps from Microsoft Store, an check if that helps.



Method 3: Reset Sticky Notes in Windows 10.

1. Open the Settings Navigate to
   Apps and then select Apps & features.
   
2. Look for the Sticky Notes
   entry and click on the same to select it. You should now see
   Advanced options link
   
3. Click Advanced
   options link to open Storage usage and app reset page.
   
4. Click the Reset button. When you see the confirmation, click the
   Reset button to reset the Sticky Notes
   app.
   
5. Restart the PC once you reset the
   Sticky Notes
   app.
   

Re-install sticky notes app from the Microsoft store and check if that helps.





I look forward to hearing from you soon.



Regards,

 

technical

We appreciate your response and efforts in trying to perform the suggested troubleshooting steps provided. To further isolate the issue, kindly answer the following:

• Were there any changes made on your computer prior to this issue?
• Are you getting any error messages when trying to launch Settings on your PC?
• What troubleshooting steps have you done so far?

Looking forward to your response.

 

AMD FX OC'ers Club

That's what the auto setting will do since you're over the 1333 mark it jumps to the next step which isn't listed or officially supported I assume by that ram.

At this point though I would suggest dropping the multi one step or .5 so that we can get something stable and possibly take the heat issue out of the picture for now.