Windows 10: How can I change my windows boot drive?

I was doing a reset of my computer and accidentally put the windows files on one of my hdd instead of my ssd. Anyway to fix this?

:)

 

Windows 7 booting off wrong drive?!?!?

Please move if this is in the wrong place.

I have two hard drives, a 1.5TB drive, and a 160GB drive. Windows is installed on the 1.5TB drive, as are all my files and programs. The 160GB drive has a bunch of old files, and apparently the bootmgr and boot folder. Nothing else is on the 160GB drive, other than media files etc.

If I remove the 160GB drive from the machine, windows refuses to boot, plug it back in, it works fine. The setup with two hard drives I have now is temporary, as the 160GB drive will go into another machine.

My question is, can someone give me a step by step on how to make windows force to boot off the 1.5TB drive, ignoring the 160GB drive in the boot process completely?
I don't know how to do this in Windows 7, on XP I would just run the /fixmbr command and its related ones.

Any help would be appreciated.

Note: I would really really rather not have to wipe and reinstall, I know it can be done without one as I've had this issue with XP before.

 

Instructions to change board?

Boot off of the windows CD, repair your XP partition (hopefully you won't have to reinstall windows), install drivers, and you're good to go. You'll see dual channel mode in the BIOS splash screen results from POST. It'll be pretty obvious *Stick Out Tongue . Here's a list of general tweaks for the 939Dual-SATA2.
Step one- Set time, date
Step two- In CPU settings, disable cool n quiet, set memory clock to DDR400, play with memory timings (CAS-TRAS-TRP-TRCD), which are listed in the bios in the order CAS, TRCD, TRAS, and TRP. EDIT- new BIOS's mess around with this order, can't be too sure on it, but yeah at least you know what the RAM timings stand for *Big Grin .
Leave MA timing at 2T unless you think your system can handle 1T
Step three- in Chipset settings, enable onboard LAN, disable onboard Audio, disable AGP fast write, set primary graphics adapter, and set CPU-NB and NB-SB link speed to 1000mhz.
Step four- in IDE, disable controllers you aren't using. On all drives detected, enable SMART if you can and set PIO/DMA as high as they will go.
Step five- Enable legacy USB support
Step six- Set password if you're worried about anyone screwing around with your BIOS settings
Step seven- Configure your boot sequence. I reccomend hard drive first, optical drive second, and floppy drive third.
Step eight- Save changes, boot into XP, and enjoy your computer.

 

Hard drive/ OS issue

a guy suggested :

• shutdown
• unhooked HDD
• restarted
• yay !!
• reconnected HDD
• restarted
• yay !!

also , try method 3
How to Unlock Drive in Windows 10: 5 Ways to Remove a Lock