Windows 10: How can I fixed the windows logo and dots spinning on my asus laptop?

Hello, I have tried everything I could to fix my laptop even taking it to a computer repair place near me and I still don’t have it fixed.I have made a windows reinstall flash drive and I am trying to run it, it lets le select the windows 64 bit option and does the loading files bar but then it goes to a windows logo and spinning dots. I know it’s supposed to go to this before it pops up with the windows setup but it won’t. It just stops with the windows logo and the spinning dots. I left it overnight and woke up with it still doing this.Then I tried pressing more Function keys and later got

:)

 

Windows 10 Stuck on logo screen with spinning dots

This suggestion isn't helpful at all. If I can't even get past the boot screen with spinning dots there is no way to access the recommended steps.

I have two Windows 10 computers. This afternoon I left my backup desktop at a repair shop because the screen goes black after I log in. They've seen this with quite a few Windows 10 computers. This evening my primary computer (laptop) won't get past the
Microsoft logo screen.

Ive been using Windows computers for over 20 years and never encountered this level of difficulty until Windows 10!

 

Stuck on startup HP logo spinning dots

On my HP Envy 17 j177nr, after I booted up windows this morning, all seemed fine until about 30 minutes into using it. Forza Horizon 5 would not run and I began having intermittent freezing issues. The freezing issues were not horrible but it was annoying just enough for me to restart my computer. Normally a restart or two fixes this kind of problem—not today though. I told Windows 10 to restart but then I got to the blue "Restarting" screen with spinning dots and it sat at the restarting screen for 30 minutes and it would not restart. So, I held the power button to turn off the laptop. Upon powering the laptop back on, it went to the HP logo with spinning dots, which is the normal startup screen, but now it has sat there at the HP logo with spinning dots for more than 45 minutes now and it refuses to boot further!' I Googled the problem but only spammy dodgy results showed up that want me to install their shady software to fix the problem. Which is very stupid, because you cannot install anything anyway if you cannot even get into Windows. How can I fix this? I cannot even use my PC because I cannot get past this HP logo

 

Windows Won't Start - Infinite Spinning Circle of Dots

No power failures or electrical storms. No changes made to the system (though when I shut down four hours earlier, it took a bit longer than usual, leading me to believe that an automatic update may have been installed). Was there an automatic update pushed
out on March 1st?

Yes, POST and BIOS appear to be fine. No warnings, beeps, or logged errors. The BIOS configuration appears to be unchanged. Drives are all recognized and the RAID 1 array shows both drives "functional."

Again, I cannot get to the recovery menu. All attempts to power up this machine end up at the infinite spinning dots.

Same thing with the Windows 10 installation DVD - spinning dots. I cannot get to the recovery menu or even re-install Windows.

There's not much more detail I can provide. It's always the same:

• Press the computer's power button
• Computer displays routine startup BIOS status messages - no warnings; all SATA drives are recognized
  
• Computer displays black screen with "Asus" logo and message at bottom of screen: "Please press DEL or F2 to enter UEFI BIOS setting."
  
• Computer's USB keyboard and mouse are functional - I can press Del or F2 to enter BIOS
• Computer displays RAID configuration with all drives status "functional"
• Computer's USB keyboard and mouse are still functional - I can press Ctrl + I to enter RAID config utility
• Black screen with "Asus" logo appears
• Spinning dots appear under "Asus" logo
• NumLock light on keyboard goes out
• Pressing Ctrl + Alt + Del has no effect - keyboard appears to be non-functional
• Nothing else happens - spinning dots keep spinning indefinitely

The only change to this routine is that every third reboot produces the "Preparing Automatic Repair" message in Step #7, underneath the "Asus" logo. Otherwise, everything is the same. The routine continues from Step #8 to Step #11.

And if I boot from my Windows 10 installation DVD, I'm given a message after Step #6: "Press any key to boot from CD or DVD....." Whether or not I press any keys, the routine continues without change from Step #7 to Step #11.