Windows 10: How can I get access to my computer after a factory reset?

After not using my pc computer in over three months, I tried starting it again only to find out that it wouldn't display anything on my monitor. After experimenting a bit, I found out that it seemed to be an issue with the pc's HDMI ports, neither of which would work. I then decided to see if a factory reset would fix it, so I dug into my pc, removed the battery from the motherboard, and drained the power, as that is what the internet told me to do. I then put it back together, and tested it out again. It didn't work, but I realized that my graphics card had an HDMI port, and when I used it, t

:)

 

One computer cannot access other network computers.


So I've tried every troubleshooting step I know:

• Double checked that Net Bios was enabled
• Ran a bunch of network commands:
  • flushed DNS
  • registered dns
  • pinged and located the named computers successfully
• Reset my router to factory settings

Nothing works when I try to access via explorer. I'm still baffled by the fact that every other computer can access each other AND access this computer. It's just the outgoing connection from this machine that doesn't work.

Any thoughts?

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Windows 10 factory reset

Hi Charlie,

We can see here that you are having issues with doing a factory reset on your Windows 10. There are several factors
why you get the said error and that's what we are going to figure out. To isolate this concern, may we know the following:

• Any changes made on the computer prior to this concern?
• What troubleshooting steps have you tried so far?
  
• May we know the reason why you want to perform a factory reset?
• Did you experience any issues on the computer before you tried performing a factory reset?