Windows 10: How can I make my ssd the main boot drive?

Hello, so I recently Installed windows to my new Kingston ssd and I have noticed that it does not display in my bios as the main boot drive for UEFI. So whenever I have to turn off my computer or restart it I have to press f9 boot drive selector and manually select my ssd to boot off of. When I look in the bios boot settings I see my hdd under UEFI but on the other hand my ssd is on the Legacy boot order. Is there a way I can change this?

:)

 

SSD as Boot Drive? How?

Well, I have Windows installed on the SSD, along with the drivers and browser. Now, I'm trying to install other stuff (Steam, games, etc.), but the mechanical drive isn't showing. I'm sure I missed a step?

 

New SSD wont boot

Hi John

Boot into BIOS, is SATA Mode set to AHCI to enable booting from an SSD drive?

Is the SSD drive set a top of the Boot Priority list?

Did you try connecting that SSD to the SATA Port normally used by your old HDD?

 

Cloning to SSD then swapping drive letters


@SamHobbs
What you want done is very simple and can be done in short period of time. Here's my suggestion:
There's 2 modes that Windows can be installed: UEFI and the old legacy MBR. Open Disk Management, look at the disk where your C drive is, if there's a

1. EFI System Partition, your Windows was installed using UEFI.
2. System Reserved partition, your Windows was installed using MBR

Next, Connect your SSD to an available Sata port (no need to format or do anything). Download: Macrium Reflect Free . Install and run. Follow the steps below:

1. From Macrium, click on image this disk under your C drive and save it to either an Internal or External Drive. This will create a single backup image of the whole disk containing your C drive.
2. Again, from Macrium, click on Restore tab and select the image created from step 1, Select your SSD as the destination drive, click Next->Finish
3. Exit Macrium. If your Windows was installed using MBR, Open disk management and make sure the SSD is marked "Active" else go to next step.
4. Shutdown your PC. Disconnect the HD containing Windows C drive then connect your SSD to it.
5. Reboot. Your PC should boot and the Windows should have C as the drive letter.

NOTE: The procedure above is to backup your Windows to an image file then copy it back to the SSD. This ensures proper cluster size aligment for the SSD. In addition, Macrium also perform Trimming for the SSD. This is more preferable than cloning.