Windows 10: How can I prefer another IP in my home network?

Hi,

I'd like to use my static IPv6 instead of the temporary for outgoing connections in my network at home, so the servers are able to recognize the client.

I couldn't find anything. route and New-NetRoute doesn't allow to enter source IP-adress.

submitted by /u/Yamaii
[link] [comments]

:)

 

Network and internet

Hi,

Based on the details provided, it is also possible that your
TCP/IP
is not communicating with your network hub causing the IP conflict.
We recommend that you reset and reconfigure your TCP/IP.
Resetting and reconfiguring your TCP/IP
will help your network hub to communicate properly with your PC. To
reset and reconfigure your TCP/IP, follow the steps below:

Reset TCP/IP.

To do this, follow these steps:

• 
  Run
  Command Prompt
  as
  Administrator.
  
• 
  Run
  this command:
  
  • 
    netsh
    int
    ip reset
    and hit
    Enter.
    

Exit
Command Prompt
and
monitor your Network Connection.

Reconfigure TCP/IP.

To do this, follow these steps:

• 
  Run
  Command Prompt
  as
  Administrator.
  
• 
  Run
  these following commands:
  
  • 
    netsh
    int
    tcp set heuristics
    disabled
    
  • 
    netsh
    int
    tcp
    set global
    autotuninglevel=disabled
    
  • 
    netsh
    int
    tcp set global
    rss=enabled
    

Update us on how it goes.

Regards.

 

Set Broadband Internet Connection Network Configuration

Hi,

Upon analyzing the details you have provided, kindly run the
Network and Internet Troubleshooter
and check if there's any changes. To run the
troubleshooter,
follow these steps:

• 
  On the search bar, type
  Troubleshooting.
  
• 
  Choose
  Network and Internet.
  
• 
  Run the following
  Troubleshooter:
  
  • 
    Internet Connections.
    
  • 
    Network Adapter.
    
  • 
    Incoming Connections.
    

If the issue persists, we suggest that you try to
renew
your
IP address. To do this, follow these steps:

• 
  Open
  Command Prompt
  as
  Administrator.
  
• 
  Type the following command:
  
  • 
    Ipconfig/release
    and hit
    Enter.
    
  • 
    Ipconfig/renew
    and hit
    Enter.
    
  • 
    Exit.
    

Let us know how it goes.

Regards.

 

IP Address Bandwidth Monitor

I am looking for a bandwidth monitor that tells me how much bandwidth each IP connected to my server is sending/receiving (preferably listed in Mbits). I currently have Netlimiter 2 Pro, but that only does bandwidth monitoring by process (it lists IPs but doesn't tell how much bandwidth each one is using). It would need to run on Windows Server 2003 and not have any web-based requirements (it is not a webserver so can't support a webpage-type monitor). Does anyone know how to do this? Any suggestions would be greatly appreciated.

Brendan "NinjaNife" West