Windows 10: How can I restore my data from the USB?

I worked on a laptop with data on a USB stick. The computer asked for a restart - so I gave it to him and after the restart there is no data on my USB stick and even this USB stick has a completely different name. When I plug in the USB, it asks to format it but I'm afraid to start it because I don't know if I'll lose all the data if it's there somewhere, and when I want to open or disconnect it, it displays other messages like: 1. The volume does not contain a recognized file system. Please make sure that all required file system drivers are loaded and that the volume is not corrupted.2.

:)

 

Restoring Windows 10 Image using Macrium Reflect


In addition to the above. Here's my suggestion in step by step.
I assume you have Macrium Installed in your current HD and already made a backup copy.

1. Connect your new HD via USB port and boot up.
2. Run Macrium, click on Restore tab then select the Backup Image that you made to restore
3. click on "select a different target disk" then select your new HD as destination
   
   
   
4. Proceed to restore then Shutdown and disconnect the old HD and replace with the new HD
5. Boot up with your new HD.

 

USB settings in Power Plan Options on Windows 10 is missing, how to restore it?

As per the below suggested steps I am trying to disable the USB in USB selective suspend setting in my Dell laptop with Windows 10 Home. however, I do not find the USB Settings at all in two modes Balanced mode or Dell (Active) mode under change advanced
power settings. How to restore it?

USB Selective Suspend Settings, follow the steps below:

1. Press Windows + X.
2. Choose Power Options.
3. Select Choose when to turn off the display.
4. Open Change advanced power settings.
5. Expand USB settings and USB selective suspend setting.
6. Select Enabled (default) or Disabled.
7. Click Apply, then OK.

 

Lost data from hard drive, what to do now?

Well, I'm sorry to hear that it's a WD My Passport that failed on you, @tomhenry ! *Frown
I'd recommend you to try using a different USB cable with it and see if that will help your system to detect it without it disconnecting.
I'd also suggest you to go to Disk Management and see how the drive is listed there. It won't hurt to check up on the health and SMART status of the HDD by running the QUICK and EXTENDED tests from the WD's Data LifeGuard Diagnostics. Here's a link to the available software: http://products.wdc.com/support/kb.ashx?id=11ZOpD

Give these troubleshooting steps a try and keep us posted with the results!
SuperSoph_WD