Windows 10: How Do I Access My Router?

What address do I enter in order to access my router? I tried 127.0.0.1 and 1.92.0.0.1. But they dont work Any suggestions?

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Unable to access my router

1. I already have a gateway configured in my house, so no, i'm not relying on this router for internet. However, I plan to make this into an access point in the very near future.

2.This is what I'm getting when i follow that step....

Autoconfiguration IPv4 Address. . : 169.254.205.6(Preferred
Subnet Mask . . . . . . . . . . . : 255.255.0.0
Default Gateway . . . . . . . . . :

So with this i tried 169.254.205.1 with unlucky results :/

 

I cant access to my wifi router

You have replied twice with no reply from OP and no discernable reason.
Reporting for spam.