Windows 10: How do I bypass fixing disk errors and use my laptop

I was using my laptop yesterday and all of a sudden it crashed and showed the blue screen my laptop had been very slow and I had to contact support I had to wait 4 hours for it to repair disk errors I started using the laptop again and just an hour into use it crashed again I had to wait for it to repair disk errors I had to leave it overnight to repair the disk errors when I woke up this morning i put on the laptop and to my horror when it was booting up it went back to the repairing disk error page I waited and watched the laptop when it had reached 99 percent it restarted repairing disk e

:)

 

Disk management console view is not up-to-date

i dont know how to fix your disk management, but i can fix your partition problems...




open up Command Prompt with admin rights. (Right click, run as admin)


enter in
DISKPART
list disk

then find the Disk number for your Raid array... lets call it number 7 ( you can tell what disk is what by the total size)
type in

Select Disk 7
List Partition (will give you a list of all the partitions..)
Select Partition 1 (im assuming you only have 1 partition on Disk 7) repeat this step if you have more partitions.
ASSIGN


that should get the array up and running ready to use.


EDITED.

any problems, post back ^^


Still EDITING *Stick Out Tongue

side question, have you tried restarting the PC?

 

Toshiba satellite laptop disk error

Hi,

This issue normally occurs when there is a faulty hard drive. To assist you better, kindly answer the questions below:

• Have you made any changes to your computer prior to this issue?
• Have you tried the troubleshooting steps provided on this
  link that was proved by Wungraileng Vashi on December 4, 2015?

If the issue persists, we suggest that you contact the manufacturer of your device for further assistance.

Regards.

 

BSOD issue after fixing another BSOD error

Hi Williams,

There are several reasons why BSOD occur, which has different resolution. To check for any corruption or the integrity of your computer's Windows, we suggest that you perform a
Check Disk by following these steps:

• Type cmd in the search bar.
• Right-click on the Command Prompt, then Run as administrator.
  
• Type chkdsk x: /r, the /r command will fix errors found on the disk.

Let us know if you need further assistance.