Windows 10: how do i fix my router

its been happening over and over again and im so tired of it every time i would connect to the internet its fine for just a second, then after like 10 seconds it would only say one network and all the other networks would just disappear and i would have no internet, i tried resetting my router, i tried resetting my IP and nothing worked, im telling you im this close to getting rid of this PC ive been dealing with this for months now and my Pacience is running out im trying to fix the problem and nothing is working

:)

 

wireless conection to router

Hi,

To better assist you, we would like to know the following information:

• Are you able to see the router's name in the wireless networks list?
• Are you able to connect to the router but unable to connect to the Internet?
• Do you receive any error message when connecting to the router? If yes, what is the exact error message that you receive?

In the meantime, we suggest that you run the Network troubleshooter. The Network troubleshooter can help diagnose and fix common connection problems. Kindly follow the steps below:

• In the search box on the taskbar, type Network troubleshooter, and then select
  Identify and repair network problems from the list of results.
• Follow the steps in the troubleshooter and see if that fixes the problem.

If the issue persists, kindly try the troubleshooting steps on the following link:

Fix network connection issues in Windows 10.

We recommend that you try the steps on the Update the network adapter driver,
Run the Network troubleshooter followed by networking commands,
Temporarily turn off firewalls and Use network reset to reinstall network devices sections.

Let us know how it goes for us to assist you further.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Need new Router

Doesn't your ISP has a list of suggested routers? If not, look for 802.11 AC Wireless routers.