Windows 10: How do I move the unallocated partition from disk 1 to disk 0 ? I'm trying to expand the...

submitted by /u/JASON--larking
[link] [comments]

:)

 

System Reserved Partition on Disk 1 not Disk 0

The results were the same as before: Windows is installed in a single 477 GB partition on Disk 0 and the System Reserved is in a 500 MB partition on Drive 1. The rest of Drive 1 is unallocated. This is identical to the configuration I had when I asked the
question.

The Media Creation Tool used to created the install ISO DVD is v. 10.0.14393 downloaded on 12/13/2016.

I followed your instructions:

• I selected Drive 0 and deleted the existing Windows partition.
• I clicked New and Apply. Windows then formatted Drive 0 as a single primary partition.
• The existing System Reserved partition was still on Drive 1.
• So I deleted the System Reserved partition on Drive 1 and the just created Primary partition on Drive 0
• I then selected Drive 0 and clicked New and Apply again. Same result a single Primary partition on Drive 0. Drive 1 was left unallocated.
• Upon completion of the install
  • Windows occupies about 15 GB in the only partition on Drive 0
  • The 500 MB System Reserved partition was placed on Drive 1
  • The rest of Drive 1 is unallocated.

How can I get the System Reserved partition to be placed as the Partition 1 on Drive 0 with Windows installed in Partition 2?

Thanks.

Bill

 

Cannot merge C drive (disk 0) with unallocated space (on disk 1)

Hi all,

I need some advice on whether it is possible - and if yes, how to merge my C drive on disk 0 with D drive on disk 1.

The problem is: my C drive is getting full soon, but previously after I deleted D drive and make it unallocated space (the bar of current D drive will change to black from blue), I still cannot expand C drive by adding the 100GB unallocated space into it.
If I right click on C drive, the "expand" item is in gray.

I've searched online for solutions but so far only have seen same questions around. Does any one know the solution and do a big favor to explain how to do it step by step? Thanks much in advance!

P.S, sorry that the interface is not in English. Below page shows the "Disk Management" function, and you can see that:

1) Disk 0 has 55.78G, including C drive (55.21GB), 100MB of something I don't know what it is, and 473MB of recovery zone

2) Disk 1 has 100GB D drive, and 831.51GB E drive

 

Allocating memory from disk 1 to disk 0

So i am wondering how i allocate memory from my disk 1 partition which has 931 gb of unallocated memory to my disk 0 partition which contains my C drive that has only 111 gb I keep getting the low disk space message so i would like to allocate memory
from the disk 1 partition to the primary disk 0 partition how would i go about this ?