Windows 10: How do I reset Mail to the default view?

Somehow my Mail's default view changed and is not showing the accounts as a list on the left. I have to click on an account icon and then the list of the accounts pops-up. I haven't been able to find any setting for this. I have repaired the app but no change. I'd prefer not to have to do a full reset or reinstallation.

:)

 

How to Change the Group by View of a Folder in Windows 10 tutorial

The delay to reply was unrelated to this topic. I was preparing to add a disc drive. The preferred view is working now, and here is the step by step list of what I did, and it includes an additional step at the end. I also rebooted after each step.

1. Reset all views to default.
2. Rebooted.
3. Changed the "My Pc" view to Details and set the "Group By" to [None]. But left everything else at default.
4. Rebooted.
5. "My Pc" view retained the selected setting, alphabetically ordered "Details" without grouping.
6. Switched to Drive C:\, set it to "Details" and changed the column order to "Name, Size Type and Date". Grouping is available but not applied by the default settings.
7. Rebooted.
8. "My Pc" lost the settings, reverted to "Tile" and "Group by" was active again.
9. Reconfigured to "Details" and set the "Group By" to [None].
10. Rebooted.
11. "My Pc" view retained the selected settings. Alphabetically ordered "Details" without grouping.

 

setting default view for Winodws Explorer Search Reasults

Thank you for the detailed response. To change the search result's view from content to list, we suggest following the steps below:

• Open the File Explorer and try to search for files.
• In the toolbar, open the View tab and click List
  to change the view.
• Once changed, close the File Explorer.
• Open the File Explorer again and try to search to see if the setting has been retained.

After performing the steps above, reply back to us so we can provide additional help.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".