Windows 10: How do I stop PC from going into Bios every time the pc is restarted/turned on?

Hi, so I have finally build my first pc, I have installed the windows 11…. Set everything up, downloaded system updates and once the pc restarted it keeps on going to bios every time I restart the pc. How do I stop this and make it so it goes straight into windows when starting pc?

:)

 

Pc bsod to bios

Currently replying on iPhone, I’ll give you a proper timeline Step 1) during the program of tuneup plus my pc bsod 3 times but I was finally able to get the info Step 2) Restore point was easy and done quick which now leads to step 3 Step 3) After starting the WDV my pc bsod with the stop code of “System thread exception not handled” following the steps I open command prompt and tried to turn it off which says that nothing was changed, so then after a couple of bsod’s later I manage to go back to my restore point which now leads to a problem I cant seem to fix where when I try to open my pc it says something is wrong with my pin with error code (0x80090016) If needed I do have the tuneup plus info Trying to solve the pin problem if anyone suggestions please inform me.

 

My pc will only turn onto the bios settings

If your PC is only turning on to the BIOS settings and you are unable to boot into Windows, it may be due to a hardware issue or a problem with the operating system. Here are some steps you can take to try and fix the issue:

1. Check the boot order in BIOS:
   

• Enter the BIOS settings by pressing the appropriate key (usually F2 or Del) during startup.
  
• Look for the "Boot" or "Boot Order" section and ensure that the hard drive or SSD that contains the operating system is set as the first boot device.
  
• Save any changes and exit the BIOS.
  

1. Check for loose connections:
   

• Turn off your PC and unplug it from the power source.
  
• Open up the PC case and check all connections between components (such as the hard drive or SSD and the motherboard) to ensure they are properly seated.
  
• Close the PC case, plug it back in, and turn it on to see if the issue is resolved.
  

1. Perform a startup repair:
   

• Use the Windows installation media (such as a USB drive or DVD) to boot into the advanced options screen.
  
• Select "Startup Repair" and follow the prompts to attempt to repair any issues with the Windows operating system.
  

1. Reinstall Windows:
   

• Use the Windows installation media to perform a fresh install of the operating system.
  
• Note that this will erase all data on the hard drive or SSD, so make sure to backup any important files beforehand.
  

If none of these steps solve the issue and you continue to see the "no bootable device detected" message, it may be due to a hardware failure such as a faulty hard drive or SSD. In that case, you may need to replace the failing component or seek professional assistance.

 

PC Build Steps

Ok just because I like steps i am going to create some steps. Please give me the stamp of approval/disapproval

• Install system in case
  • Remember to connect SSD and optical to same SATA ports on motherboard
• Turn on PC
• setup HDD
• run blend test in prime95 for 30-60 min
  • run realtemp at the same time

• While in Prime95 test
  • if CPU goes above 70c in RealTemp, I have a leaky CPU
  • if my system locks up or blue screens, there is an instability in the system somewhere
  • if my system does not lock up or blue screen, my CPU is not damaged and I am in the clear!

What do you guys think??