Windows 10: How do I transfer the operating system from one SSD to another?

Good day, I've just installed an additional M.2 SSD into my laptop. I want to migrate the OS from my first SSD to the new one.Could you assist me with this issue?If I migrate from one SSD to another, will I lose the license of my Windows OS I want to transfer the OS along with all necessary device drivers, but leave the rest of the programs and components on the old SSD?From the screenshot, I see that there are many system partitions on Disk 1 old SSD, and one of the partitions appears to be a partition possibly created for the files of my laptop's manufacturer. SYSTEMFAT32 260 MB, Prima

:)

 

Transfer System disk image to SSD


Here's my suggestion: Connect the SSD to the PC.

1. Download: Macrium Reflect Free and install then run.
   IMPORTANT: click on the 1st icon on the top left to create a Macrium Rescue disk (using USB or DVD)
2. Open Disk Management and make sure the SSD is disk 1.
   From Admin Command, type:
   diskpart
   select disk 1
   clean
   exit
   exit
3. From Macrium, The disk with Windows currently running will have the partitions as shown in your screen shot above. Click on Clone this disk...
   A Windows popup, click on select a disk to clone to...
   Click on the SSD
4. Select the 100MB "System Reserved", drag and drop to the destination (SSD)
5. Select the 60GB "C Drive", drag and drop to the destination(SSD) next to the System Reserved
6. Click Next->Finish
7. Once done, shutdown, disconnect the HD and connect the SSD Only
8. Boot up with the Macrium Rescue disk created in step 1.
9. Once booted, click on "Fix Windows boot problems" and follow the instruction to complete.
10. Remove the Rescue disk and reboot.

 

Programs not working

In post 26 there were steps listed to fix the operating system corruption.
Are you able to follow them?
In post 29 was the suggested dism repair command.

 

Transfer System disk image to SSD


The message I get when I try and install the image is
The system image restore failed

Error details: The disk that is set as active in BIOS is too small to recover the original system disk. Replace the disk with a larger one and retry the restore operation. (0x80042407)

following is a copy of the setup for image creation



The bios lists the disk as Kingston and Windows shows Kingston SV300s37A 120G (disk 0) 111.79 GB as the disk to use in the disks to exclude screen so the 111.79 is the capacity as Windows sees it. I don't understand how it can't fit a 44GB image file.