Windows 10: How do i turn off my mouse when laptop powers off and its still on?

Hello, my mouse wont turn off even if my laptop has been powered off. In "mice and other pointing devices" in device manager, under mouse properties and power management i can not turn on the option for "allow the computer to turn off this device to save power" how do i turn it on? It doesn't allow me to, thank you

:)

 

mouse is not working right


unfortunately there isn't a lot to a usb mouse. what i would suggest is checking the power management settings on it.

Right-click the start menu and choose device manager
Expand Universal Serial Bus Controllers at the very bottom
Double-click on each HUB you have listed, click Power Management Tab at the top, and UNCHECK "Allow this computer to turn off this device to save power"
You may have HUBs called Generic and Root Hub. Perform the step above on All of them.

If you continue to have the issue, i would imagine your mouse is malfunctioning. Perhaps try another mouse just to be sure. This will help you determine if it is in fact the mouse of computer causing the issue.

Good Luck!!

 

My hp laptop wont turn on

This is a frequent problem am sure as you have already seen from online searches.

Flea power is usually the culprit here, basically its residual power that remains on the computer even after thecomputer has been shutdown. You can drain the flea power with the steps the other answers have suggested.

• Disconnecting the battery and adapter
• Press the hardpress the power button for 30 seconds
• This should clear the flea power

If this doesnt work, read this article its about
a dell inspiron but the same applies for you hp. It has some detailed step by step instructions

 

Desktop Turns On When Laptop Powered Up

Hi,

Welcome to Microsoft Community.

I suggest you for follow the methods below and check if it helps in solving the issue:

Method 1: Run Power Troubleshooter.

You may try to run the Power Troubleshooter and Reset the power options.

• 
  Type “Troubleshooting” in search box and press Enter.
  
• 
  Click on “View all” on the top left pane.
  
• 
  Select Power from the list and follow the prompts for troubleshooting.
  

Method 2:

Run the in-built Network troubleshooter by following the steps below.

• 
  Type “troubleshooting” in the search box and press Enter.
  
• 
  Click on “View all” on the top left corner.
  
• 
  Click on “Network Adapter” and follow the prompts for troubleshooting.
  

Then, shutdown your PC and check.

Let us know the status.

Regards,

Guru Kiran