Windows 10: how do i use a recoevry disk

Hi! I have windows 10. I started having problems with it so I used a recovery usb drive and now it won't recovery and reset the operating system. what do I do next? it was a digital activated, from windows 7.

:)

 

Disk management console view is not up-to-date

i dont know how to fix your disk management, but i can fix your partition problems...




open up Command Prompt with admin rights. (Right click, run as admin)


enter in
DISKPART
list disk

then find the Disk number for your Raid array... lets call it number 7 ( you can tell what disk is what by the total size)
type in

Select Disk 7
List Partition (will give you a list of all the partitions..)
Select Partition 1 (im assuming you only have 1 partition on Disk 7) repeat this step if you have more partitions.
ASSIGN


that should get the array up and running ready to use.


EDITED.

any problems, post back ^^


Still EDITING *Stick Out Tongue

side question, have you tried restarting the PC?

 

DISK CLEANUP

Hello,



Thank you for writing to Microsoft Community Forums.

1. Which files are you trying to delete using disk clean up?
2. Which version of Windows are you currently using?

Please reply back with the information to the above questions in order to provide you with appropriate troubleshooting steps:



I understand that you are trying to free up memory using Disk Cleanup. If you are trying to delete files using disk cleanup on Windows 10, I suggest you to refer the following article on

Disk cleanup in Windows 10 for steps to perform disk clean up on your PC.



Hope it helps.



Sandeep Kumar M

Microsoft Community – Moderator

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!