Windows 10: How to access HD [to format it] if I cant boot properly

Hello, I want to [need to] reformat the HDD on my laptop and reload W10 onto it but i cant seem to reboot into any stage that would allow me to do this. It keeps looping into 'Preparing Automatic Repair' and it then gives me a number of choices but doesn't seem to follow through. I choose safe Boot w/internet to see if I can get in that way but that too doesn't seem work. there is something very wrong with the files/OS and I simply want to reformat and reinstal windows 10. any suggestions please.regards,

:)

 

Cannot Format HD


Need to initialize it as GPT disk type with HD > 2TB:
From Admin command prompt:

1. diskpart
2. list disk =====> Take a note of disk # for the 4TB HD
3. select disk # ====> From step 2
4. clean
5. exit

Open Disk Management and initialize the disk as GPT, create simple then format.

 

Formatting a dual boot system with windows 10 and ubuntu

Hi,

In Windows 10, you can easily format a hard drive or a partition by accessing Computer Management. For us to assist you, we suggest that you follow the steps listed below:

• Press the Start button.
• Type Computer Management.
• On the left side, click on Disk Management under Storage.
• Locate the drive that you want to format.
• Once located, right-click on the drive and choose Format.

If the hard drive has not been formatted with the steps that we have provided above, we recommend that you contact the manufacturer of your hard drive. Some hard drive requires a software that you'll need to use just to format it.

Let us know how it goes and if you need further assistance, feel free to post back.

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!