Windows 10: How to activate a hard disk using cmd

*** Email address is removed for privacy ***

:)

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

External Hard disk contents are not visible.

Hi Pranoti,

For us to narrow down your concern with your external hard disk, we would like to know the following:

• Were there any changes made on your computer prior to the issue (e.g., updates, software installation)?
• To make sure that we have not missed on anything, what troubleshooting steps have you done so far?
• Do you hear any clicking sound when connecting your hard disk?

In the meantime, we suggest that you update all your device driver.

We look forward to your response.

 

100% hard disk active time in windows11.

I already did these type of steps like formatting whole hard disk then clean install windows 11 and didn't install any third party apps only apps were windows stock

But still facing 100% active time hard disk but my hard disk usage was only 2% or 3%. My pc gets slow whenever active time reaches 100% and most of the time active time is always 100%.