Windows 10: How to clone a partition to another drive on Windows 10?

Hi,On my computer, I have my system partition A:, and another partition B: that contains all my data. Both partitions are on separate HDD.I just want to backup B: partition without the system partition.Is it possible to do this on windows 10 without using a middleware?I used Aomei, and I don't really trust these programs.Thank you.Regards, Samih.

:)

 

partition cloning help!

Well I just bought a SATA seagate 320gb 7200.10 hard drive. I had to get a power adapter, but anyway. It's in as Drive F (did disk management). Now all I want to do is clone the partition from my old hard drive to my new hard drive. Copy windows and everything else over on my new hard drive, take out my old drive and then use the new drive as the primary C drive. I have norton ghost, and partition magic. I heard ghost is much better. Could someone tell me step by step how to accomplish this? I think I know how, but I do NOT wanna take any chances here..

 

Clone hard drive partition

I cloned hard drive A from hard drive B. Hard drive B had two partitions, two Windows operating systems cloned successfully to hard drive A.

Recently Windows 10 took a dump on it's partition on hard drive A. My question is, do I boot from hard drive B to clone the Windows 10 to a like

partition on hard drive A, and, must I reformat the destination partition on hard drive A or will AOMEI partition assistant automatically take

care of that???

Any help I get on this will be greatly appreciated.

 

W7 Hard drive partition issue

to get rid of that 100 meg windows partition that setup creates for you on a new install on a blank hdd:

- press shift+f10 when on the partition management screen in setup <-- this opens a command prompt
- diskpart <-- start the windows command line partition management tool
- list disk <--- list the installed hdds in this computer for the next step
- select disk 0 <- might have to replace 0 with the number of the correct disk
- clean <-- this will erase all data on the disk you selected one step up- dont use the wrong disk!
- create partition primary <- creates a primary partition taking up all space on the drive, adjust the command if necessary
- exit, exit to exit diskpart and the command prompt
- click refresh in partition manager and select your newly created partition and install to that