Windows 10: how to connect laptop wifi to xbox by bridging

Im trying to bridge my laptop wifi to my xbox. The option has a shield and says i must select two networks that arent being used for internet sharing.

:)

 

Bridging wifi and ethernet connections – wifi keeps disconnecting

Hi all,

I am trying to use Windows to bridge my wifi connection to non wifi devices. I have successfully setup the bridge in Network Connections. However, the wifi only stays connected for a few seconds before it disconnects (everything is working as expected, with wired devices having internet access, until wifi disconnects). This seems to be something to do with the ethernet cable being connected, as when I disconnect the ethernet the wifi stays connected.

Things I have tried:

• Turning off power management and checking bios for any funky power management settings
  
• Setting "Priority & VLAN" to disabled
  
• Disabling "Automatic metic" and setting wifi to priority order – though you don't seem to be able to change this for specific connections when bridged.
  

Any suggestions greatly appreciated.

P.S. everything works fine with bridge disabled and using internet connection sharing enabled on the wifi. However I am unable to connect to devices such as printers (hence why I am trying bridged mode).

 

Unable to bridge Wireless connection from Laptop to X box

I atempting to bridge my wireless connection from my laptop to my xbox one, I have tried multiple tutorials and still nothing has worked. Can anyone help in regards to step by step process.

Original Title:Bridging connection

 

Bridge Connections (WiFi) no longer work with an unexpected error.

Hi,

There are a lot of possible factors for the bridge connections to have an unexpected errors. To isolate this matter,
I have a couple of questions for you:

• 
  Were there any changes made before the issue occurred?
  
• 
  Have you tried updating your drivers manually?
  
• 
  What troubleshooting steps have you done so far?
  

I recommend that you perform the troubleshooting steps indicated in the article entitled
"Fix network connection
issues in Windows 10".

If the issue persists, reset your TCP/IP and see if there are any changes. It is possible that your TCP/IP were
corrupted. To do this, follow these steps:

Reset TCP/IP

To do this, follow these steps:

• 
  Run
  Command Prompt
  as
  Administrator.
  
• 
  Run
  this command:
  
  • 
    netsh
    int
    ip reset
    and hit
    Enter.
    

Exit
Command Prompt
and
monitor your network connection.

Disable auto turn-off of
WiFi device.

• 
  Go to
  Network and Sharing Center.
  
• 
  Click
  Change adapter settings
  on the right pane.
  
• 
  Right-click your
  connection name
  (WiFi name)
  and choose
  Properties.
  
• 
  Click on
  Configure...
  button.
  
• 
  Go to
  Power Management
  tab.
  
• 
  Uncheck/disable
  the check box radio for
  "Allow this device to turn off this device to save power".
  
• 
  Restart the PC
  (Important).
  

Reconfigure TCP/IP

To do this, follow these steps:

• 
  Run
  Command Prompt
  as
  Administrator.
  
• 
  Run
  these following commands:
  
  • 
    netsh
    int
    tcp set heuristics
    disabled
    
  • 
    netsh
    int
    tcp
    set global
    autotuninglevel=disabled
    
  • 
    netsh
    int
    tcp set global
    rss=enabled
    

Let us know how it goes.

Regards.