Windows 10: How to Disable "Send a Code"

Huge security hole. Someone is accessing my BlueHost email, even though I've changed the password multiple times. My Windows account originally used this email. I've changed the email for Windows that is associated with my acount, and deleted the BlueHost account, but on my Windows account, "Send a Code" is enabled to that old email. The hacker simply sends my email to Microsoft, gets the code, and access all of my documents via Office 365 storage, and I get screwed over again. I've changed all of my emails for the account, but Advanced Security won't let me either turn off Send a Code, o

:)

 

email won't send from Outbox on my nokia

Hi,

To isolate the concern, please answer the following questions:

• Which phone and OS version you're currently using?
• What is the error code that you received?
• What troubleshooting steps have you done so far?

We also suggest you to send us a screenshot of the error code that you've received.

Sincerely.

 

Send to onenote

Hi,

It may be an issue with the add ins in OneNote, we suggest that you disable OneNote add-on and enable it. To do so, follow the steps below:

• Open Internet Explorer.
• Click Manage add-ons.
• On the left pane, click Toolbars and Extensions.
• On the right hand side of the page check for Send to OneNote add-on. Highlight
  Send to OneNote and click on disable.
• Once the add-on is disabled highlight the add-on again and enable it.

Note: To enable the File menu in Internet Explorer press the
Alt key on your keyboard.

You may also perform an online repair in Office 2007, to do an Online repair, follow the steps below:

• Press Windows + X.
• Click Control Panel.
• Click Programs and Features.
• Right click Microsoft Office, click Change.
  
• Choose Online repair.
• Follow the on-screen instructions.

Let us know how it goes.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".