Windows 10: How to enter into cmd in recovery mode without admin account and bootable flash drive/disk

I try to go into cmd using the recovery mode method but it states that i dont have a administrator account and i cannot use a boot device Disk Flash Drive etc. Is there any way i can get into cmd without having to do these things?

:)

 

Bootable USB with ISO - What am I missing?

I am trying to install win7 from a USB. I set the USB to be first boot and it finds it, but wont install the iso.

I have tried ...

However when I get to bootsect it does not do anything .. says it is not a recognized internal command ...

Is there something I am missing? I even tried just loading the iso on the USB and booting, but did not work either

Is there an easier way?

 

Windows 10 Recovery drive error - Can't create a recovery drive on this PC

I inserted a new USB drive into my laptop, started drive recovery and after a
while it found the drive. However, on proceeding with the process I was then getting the error message “We can’t create a recovery drive on this PC”.

The steps I took to resolved this were:

• Create a new partition on the USB drive.
• Reformat the USB drive as NTFS
• Make it bootable
• Re-run the Windows 10 Create Recovery Drive utility

I am not sure that steps 2 & 3 are required as the utility will reformat the drive anyway but I haven’t tested this process omitting them.



Detailed instructions are as follows (thanks to
www.indestructables.com for pointing me in the right direction here)

• Insert your USB flash drive to your running computer. As the first step, we need to run Command Prompt as administrator. To do this, we need to find cmd by typing 'cmd' in the search box on Windows Start Menu. After search result for 'cmd' appears,
  right click on it and select "Run as administrator".
• Type 'diskpart' on Command Prompt (without quotes) and hit Enter. Wait for a while until the DISKPART program run.
• Type 'list disk' to view active disks on your computer and hit Enter. There would be seen that the active disks shown as Disk 0 for hard drive and Disk 1 for your USB flashdrive with its total capacity.
• Type 'select disk 1' to determine that disk 1 would be processed in the next step then hit Enter.
• Type 'clean' and hit Enter to remove all of data in the drive.
• Type 'create partition primary' and hit Enter. Creating a primary partition and further recognized by Windows as 'partition 1'.
• Type 'select partition 1' an hit Enter. Choosing the 'partition 1' for setting up it as an active partition.
• Type 'active' and hit Enter. Activating current partition.
• Type 'format fs=ntfs quick' and hit Enter. Formatting current partition as NTFS file system quickly.
• Type 'exit' and hit Enter. Leaving DISKPART program but don't close the Command Prompt.
• Type 'bootsect /nt60 d:' and hit Enter. Creating boot sector on D: drive (USB flash drive)

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!