Windows 10: How to find what program is using SetThreadExecutionState to cause exit from Modern Standby?

My laptop has been exiting Modern Standby for unclear reasons. Network connectivity during standby is disabled and ability to wake from sleep is disabled for all devices in Device Manager.Just had a situation where laptop was supposedly on sleep for 4 days, but it turns out it had exited standby 6 hours after entering. Event Viewer contained the following2024-04-10 08:09:23 - Connectivity state in standby: Disconnected, Reason: Policy Setting2024-04-10 14:08:29 - Connectivity state in standby: Connected, Reason: None2024-04-10 14:08:32 - The system is exiting Modern Standby. Reason: SetThreadE

:)

 

Is there any OS function that let us check system is going to enter modern standby?

Hi,



Thank you for writing to Microsoft Community Forums.



Windows 10 Modern Standby (Modern Standby) expands the Windows 8.1 Connected Standby power model. Connected Standby, and consequently Modern Standby, enable an instant on / instant off user experience, similar to smartphone power models. Just like
the phone, the S0 low power idle model enables the system to stay up-to-date whenever a suitable network is available.



We would suggest you to refer these articles for additional information:

What is Modern Standby?

Prepare software for modern standby

Modern standby SleepStudy



However, as you are into software development. Let me point you in the right direction, where you would get the appropriate help for this issue. I would suggest you to post your query in
MSDN forums, where we have experts and support professionals
who are well equipped with the knowledge on Modern Standby to assist you with the appropriate troubleshooting steps.



Regards,



Aditya Roy

Microsoft Community – Moderator

 

how do i enable modern standby

Please do follow up on the suggestion you received from Saltgrass. Modern Standby, if supported, is enabled in the UEFI.

 

modern standby problems entering to sleep

Laptop Dell XPS 7590 Windows 10 2004build.

I press the power button, laptop starts going to sleep, then if i was lucky enough when i close the lid after some time laptop stops responding to ping.

But in most cases laptop just not going to sleep at all. Then if i look to event viewer i see events:

Event 506: The system is entering connected standby

Reason: Power Button.

Event 507: The system is exiting connected standby

Reason: Lid.

Event 506: The system is entering connected standby

Reason: Lid.

Event 507: The system is exiting connected standby

Reason: Input Keyboard.

Interesting thing, event shows that was keyboard input, but how this could happen if the lid was closed, and i was closing it gently.

And i can not disable modern standby, cause it is a new "feature", so hibernate is the only choice ????