Windows 10: HOW TO FIX CRITICAL PROCESS DIED error with the advanced and new methods

I have an error called critical process died I have tried various methods like boot rec fix mbr etc but non of them are working including safemod and also I don't have a USB can you list various methods to fix this problem system restore even don't work as it says the following 0x80070002 error and also sfc scan says windows resource protection could not perform the requested operation dism also no work so can you give me ways to fix this error

:)

 

Critical Process Died Error


Recently while using the internet my computer experienced a BSOD which listed the Critical Process Died as the error. Before this happened my computer kept popping up with a message I believe was saying that the display adapter driver crashed and then was recovered. It should also be mentioned that I recently upgraded my system with a new graphics card, after my old one died, and with a new case. That was my first time ever doing something like that, so I wouldn't be surprised if that could be a problem.

 

BSOD Critical Process Died




This is my config, what should i do?

- - - Updated - - -

I tried also this:
Step 1. From the initial Windows screen, accept the default settings for the language to install, the time and currency format as well as the keyboard or input method. Next, click the Repair your computer link instead of Install now.

choose Repair your computer
Step 2. Select Troubleshoot and then Advanced Options.

Step 3. Select Command Prompt.

Step 4. Type diskpart and press Enter key.

Step 5. Type list disk and press Enter. Now pay attention to the disk number and identify which one is the boot disk. Usually, it is Disk 0; if not, find the disk number in your own case and remember to type the correct one in the following relevant steps.

Step 6. Type select disk 0 and press Enter.

Step 7. Type list volume and press Enter. Now pay attention to the volume number of the EFI partition.

Step 8. Type select volume N and press Enter. Also, type the one in your own case instead of N.

Step 9. Type assign letter=N: and press Enter. N: can be replaced by any drive letter that is not taken by any partition. Remember which drive letter you assign here for it is rather useful in the rest steps.

Step 10. Type exit and press Enter to leave diskpart.

Step 11. Now type N: (the drive lettered you just assigned) and hit Enter.

Step 12. Type format N: /FS:FAT32 and hit Enter.

Step 13. Type bcdboot C:\windows /s N: /f UEFI and hit Enter.

Now repeat the process of running the bootrec /fixboot command, bootrec access is denied Windows 10 should be solved now. But if fixboot access is denied occurs on an MBR disk, continue with Fix #2.

All steps until 13. was executed successfully, but still became on
bcdboot /fixboot
Error: Access is denied. And I have a GPT and no MBR Partition

bootrec /rebuildbcd
was successfully, founded Win installation: 0 (ZERO)
complete

bootrec /scanos found also ZERO installations

 

critical process died

Hello,

Please try suggestions mentioned here:

[FIX] CRITICAL_PROCESS_DIED BSOD In Windows 10

Hope this helps, Good luck