Windows 10: how to fix disk error after creating restore point

there is noting here

:)

 

creating a restore point

Hi Anthony,

We understand that you're having an issue with creating a restore point. For us to further assist you, we'd like to gather additional information.

• Have you tried creating system restore point manually?
• Have you tried any troubleshooting steps before posting this concern? If yes, what are those?

If you haven't created a system restore point manually, you can refer to the article below and follow the instructions given. Disable your antivirus or security software and then try to create a system restore point manually.

Create a system restore point

Looking forward to your response.

 

Create restore point does not stop

Hi Nigel,

Restore points are usually saved in
Local Disk (C), kindly check that the Local Disk (C (System) is
selected when creating a restore point. If it is correctly selected and the issue still persists, kindly go to the
Local Group Policy Editor
and check if the
"Turn off Configuration"
and
"Turn off System Restore State"
is set to
Not configured. To do this, press
Windows key + R, type
GPEdit.msc
and hit
Enter. Go to the location
Computer Configuration > Administrative Templates > System > System Restore and check if both state is set to "Not configure".
If it is set to the correct state, perform these troubleshooting:

Check Disk:

To do this, follow these steps:

• 
  Access
  Command
  Prompt as
  Administrator.
  
• 
  Type
  chkdsk /f /r
  and hit
  Enter.
  

Run SFC Scan: 

To run an
SFC scan, follow these steps
(Kindly perform it 3 times):

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type
  sfc /scannow
  and hit
  Enter.   
  

Run DISM Tool: 

To perform
DISM, follow these steps:

• 
  Run
  Command Prompt as Administrator.  
  
• 
  Type the following command:  
  
  • 
    DISM.exe /Online /Cleanup-image /scanhealth  
    
  • 
    DISM.exe /Online /Cleanup-image /Restorehealth  
    

NOTE:
This might take a while to finish scanning.
Do not cancel (after running DISM, run SFC again 3 times).

If the issue persists, kindly provide us the screenshot of the return message so that we can investigate this matter
further.

Let us know how it goes.

Regards.

 

Want to create restore point

Hello,

This is Sudha Independent Advisor and user like you. Please follow below steps to solve your issue

1. In the search box on the taskbar, type Create a restore point, and select it from the list of results.

2. On the System Protection tab in System Properties, select Create.

3. Type a description for the restore point, and then select Create > OK.

reference link :
https://support.microsoft.com/en-us/help/402753...