Windows 10: How to fix power saving mode problem

My windows 7 ultimate pc won't switch on, it keeps on saying 'power saving mode' and then the screen goes blank. I tried everything on the internet I cleaned my ram, I took out my cmos battery and the pc worked for while until it did the same thing again. I put back the cmos battery back but it made no difference. What should I do?

:)

 

Problem with the power saving mode

Hello,

I've had a problem with power conservation for a few weeks now. Normally my procedure is the following:

1. Putting the PC into power saving mode
2. Switch off the connector strip to which the PC is connected
3. Next time switch on the power strip and start the PC

Windows Version: 2004, Build: 19041.264

Before that, all the programs I had open before power saving mode were open. Now I have the problem since a few weeks that the PC boots normally and all programs are closed. This is not so nice, because I always have relatively many programs open, so I always have to restart them, which takes some time.
Does anyone know by chance what this could be due to?

Greeting

 

power saving mode after a few minutes on gaming

My friend had a similar problem on his older desktop. if its similar it is a problem with your graphics card overheating or dying. two steps to take would be to open the computer and clean the graphics card cooler thoroughly. And second of all get a friends graphics card and try his in your computer. this will rule out completely any problems with your graphics card. Which i think it is.

Btw. its not your pc outputting "power saving mode". but instead its the monitor saying power saving mode since your graphics card is crashing and the screen is not recieving a signal and going to standby.

 

Windows power saving mode

Hi,

Thank you for posting your query in Microsoft Community.

I understand the issue that you are currently facing, we will try the best we can to resolve your issue.

The issue could be due to incorrect power settings.

I would suggest you to follow the below methods to fix the issue:

Method 1: Run the power troubleshooter. Follow these
steps.

Windows 10 has a built-in troubleshooter to check and fix issues with power. I would suggest you to run this troubleshooter to check if the issue is with your Power.

Refer these steps:

1. Press Windows key +X, select Control panel.

2. Change the view by option on the top right to Large icons.

3. Click on troubleshooting and click on the view all option on the left panel.

4. Run the Power troubleshooter.

Method 2: To see the power-saving settings for the printer,

1. Go to “Device Manager.”

2. Click the arrow beside “Printers” to show your printer, then right-click on the printer and choose “Properties.”

3. Click the “Power management” tab and then uncheck the box beside “Allow the computer to turn off this device to save power.”


4. Click “OK” to save your changes.

Hope this information helps. Please let me know if you need further assistance.