Windows 10: How to fix repetitive bluescreening that it makes wait 2 hours and not letting factory reset

My friend and I are trying to figure out what's wrong with his pc because it keeps bluescreening for no reason and making him wait 2 hours to turn it back on. My friends pc always bluescreened for no reason even as soon as he turns it on but about a month ago when all of our friends were starting the 2 week minecraft phase my friend couldn't play because he had an "outdated client" so he tried to update his minecraft through the Microsoft store and it wouldn't let him, it kept saying error. So after, he decided to factory reset his computer but it would let him, it kept saying error. So is the

:)

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

Windows 10 Factory Reset Failed

Thank you for your response DaveM121

No, nothing else is connected to my laptop at all. I attempted the factory reset through the command prompt because it would fail (several times) by using the steps you're suggesting. It began the process and I waited at least 4 hours for it to slowly reach
a higher percentage (it got to more than 80%) and when I looked at the laptop again, there was a failure message.

 

Factory reset

Hello darrylwelch,

I'm Independent Advisor and Microsoft MVP, here to help you with your question.

If factory reset doesn't works, I suggest you to make clean install.

Please refer this step-by-step guide:

https://www.kapilarya.com/how-to-make-clean-ins...

Hope this helps!

Note: Included link in this reply refers to blog post by a trusted Microsoft MVP.