Windows 10: How to fix system error code 1450 / Occurs when an application c++ accesses a network...

My Application was made with vs100.At first, My App opened a session on the network drive and it worked, but after about 5~6 hours of idle time, it ended. Then, it restarted immediately and tried to connect to the same network drive with wnetaddconnection2, but it did not proceed because a 1450 error occurred.What does this lack of system resources mean?Actual memoryRAM was about 10 GB of free space.And the server os was Windows server 2016 x64Is the number of network drive sessions limited? Or is there a separate memory limit for network drive access?

:)

 

when i rebuild bcd,run bcdedit /export c:\bcdbackup,An error occurred

an ERROR IS The storage export operation has failed and the system cannot find the specified FILE

because when laptop startup,screen display Not connected or unable to access the required device
Error code 0Xc000000e

but，i run bcdedit /export d:\bcdbackup,The screen shows that the operation was successful

I run these commands step by step

1.bootrec /fixmbr

2.bootrec /fixboot

3.bootsect /nt60 sys

4.bootrec /fixboot

5.bcdedit /export c:\bcdbackup

6.attrib c:\boot\bcd -h -r -s

7.ren c:\boot\bcd bcd.old

8.bootrec /rebuildbcd

An error occurred in the fifth step

i use diskpart and list volume

Disk C is only 260M, Disk H is the system disk, Disk D is a removable disk

so What command should I enter in the fifth step

 

Network PC Win10 1903 issue Error Code 0x80070035

i followed these steps, but no matter what, i couldnt stop network list services.

"windows could not stop the network list service on local computer. error 1061: the service cannot accept control messages at this time".

also, which pc am i meant to be running this fix on? both PC's reported error 1061.

 

Can't access computers on local network error code: 0x80070035

Hi Laimislr,

Thanks for your reply,




Microsoft allows computers with Microsoft Windows operating systems and sharing the same network to have access to the files and data on each other's computer without cables. But the initiating user might see the message saying
that Error code: 0x80070035. I suggest you to follow the below steps, and check if that helps.



Make sure your drive is shared.

To do that,

1. Right-click on the drive located on the target computer that you attempt visiting, for example, C: drive, and select Properties.
   
2. Click on Sharing tab and check if the network path says Not Shared.
   
3. If it's not shared, click Advanced Sharing tab.
   
4. Mark the Share this folder check box and make sure that the Share name is typed correctly.
   
5. Click Apply and OK to save the changes.
   
6. Finally, press Windows key + R, type the name of the shared folder, and press Enter.
   
   
   

We await your response.

Regards,