Windows 10: How to fix this problem with Realtek HD Audio manager

Hey! I recently got a used computer, so i took the hard drive from my old one to my new one and installed drivers, when i plug in headphones they always show up as "Line in" and when i unplug them it shows up as Headphones, this is on a Toshiba Sattelite.

:)

 

Realtek HD Audio Manager missing

Hi,

My name is Mohammed Shuaib, an Independent Advisor and I'm here to assist you with the issue of Realtek HD Audio Manager missing. Please follow the steps in the below article to fix the issue.

https://www.guidingtech.com/fix-realtek-hd-audi...

Let me know the status after performing the above.

Regards

Shuaib

Independent Advisor

Standard Disclaimer: There are links to non-Microsoft websites. The pages appear to be providing accurate, safe information. Watch out for ads on the sites that may advertise products frequently classified as a PUP (Potentially Unwanted Products). Thoroughly
research any product advertised on the sites before you decide to download and install it.

 

"Playback Device" not showing up in "Device advanced settings" in the Realtek HD Audio Manager

Hello Aditya,



Welcome to Microsoft Community.



It sounds like you're experiencing a common issue with Realtek HD Audio Manager where the front panel audio and back panel audio are treated as a single audio device instead of separate ones. Here are a few things you can try to fix the issue:

1. Update your Realtek audio drivers: Go to the Zebronics website and download the latest Realtek audio drivers for your motherboard model. Install them and see if the issue is resolved.
   
2. Check your audio settings in Windows: Open the Windows Sound settings by right-clicking on the speaker icon in the taskbar and selecting "Open Sound settings". Under the "Output" section, check if your headphones are listed as a separate playback device. If not, right-click in the window and select "Show disabled devices" and "Show disconnected devices". If your headphones appear, right-click on them and select "Set as Default Device".
   

If you already have Realtek HD Audio Manager installed on your device, the following steps may help:

1. Enable front and rear audio playback: Open the Realtek HD Audio Manager and click on the gear icon in the top right corner to access the settings. Under the "Device advanced settings" section, check the box next to "Make front and rear output devices playback two different audio streams simultaneously". This should enable separate playback for front and rear audio devices.
   
2. Disable front panel jack detection: In the Realtek HD Audio Manager, go to the Connector Settings tab and uncheck "Enable auto popup dialog, when device has been plugged in". This will disable the front panel jack detection and may enable separate playback for front and rear audio devices.
   

These steps involve the use of software from three parties, and since they are not Microsoft programs, my instructions may not be absolutely correct, and the solutions you find online may not be correct. Therefore, I suggest you consult the motherboard customer service for targeted guidance.

Hopefully, one of these solutions will help you resolve your issue.

If anything is unclear, please do not hesitate to let me know.



Best regards,

Mitchell - | Microsoft community support expert from MSFT

 

Realtek hd audio manager

Your laptop comes with new realtek audio console, so the old realtek hd audio manager is not going to work.