Windows 10: How to format a new SSD and make it bootable?

I would like to know on how to format a new SSD and make it bootable.Does anyone have any suggestions?Thanks in advance

:)

 

How To Format A Write Protected Flash Memory ?

¿You already tried this one?...

Run CMD


1. diskpart
2. list disk

Then in the 3º step, put the correct number of disk in the list for the usb flash (if it's listed in disk 3, then you'll have to write select disk 3).

2. select disk #
3. clean
4. create partition primary
5. select partition 1
6. active
7. format fs=fat32
8. assign
9. exit

with that commands you will format the flash drive in fat32, if you have a large drive you can select also "format fs=ntfs" in step 7.

good luck!

 

Ssd wont format

Hello there. This is Emily.

I assume you are installing from the ISO flash drive right? If so, at the step where it asks you where to install Windows, instead of using the format option, use delete option instead. Delete every partition listed for the SSD. It might say Drive 0 or Drive 1, etc, but you should be able to tell which drive is your SSD based on the size. Once all partitions are deleted, you would be given one unallocated space. That's the one you can select, then click next for Windows to install.

 

Multi-bootable USB

Hey guys from TPU, couldn't find any specific thread pertaining to the question asked on title. As mentioned, I'm trying to create a bootable USB, but with many specifics boots available.

I've been trying to create one with multiple boot device including one that enables me to run Windows 10 directly on the USB Thumb Drive but to no avail.

The list of bootable images i'm trying to create are

1. Windows 10 (A full OS running from thumb drive)
2. Windows 10 ISO (Bootable disk image for fresh install)
3. MemTest86+

Have tried YUMI or UUI from the website USB PenDrive Linux but as this is my first time, i don't know how am i screwing up or am doing it right.. Anyone got a rough idea on a step by step guide? Thanks!