Windows 10: How to get the IP address and Port info for a RDP client?

Hi,I'm trying to find the way to discover the source public IP and port which was used to establish the RDP connection. I tried the following ways:1 Audit log event 4624, only source IP is included, the source port is empty for RDP.2 Terminal services local session manager event 21, only IP info is there.3 WTSQuerySessionInformation with WTSClientAddress. This IP is reported by the RDP client, the IP address might be not the actual public IP, and there is no port info either.4 I cannot use the "netstat" way to find the correct port info. Think about the following situation, there are tw

:)

 

Finding IP address

Hello,

Thank you for writing to Microsoft Community Forums.

I suggest you to follow the steps mentioned below to find printer’s IP address:

1. Type Devices and Printers in the Windows search bar.
   
2. Select on the printer and click on
   Manage.
   
3. Click on the Ports tab.
   You will be able to find printer’s IP address under the ‘Ports’ tab.
   

Few printers also have a “Test print” option on the printer. When you print a test page from network printer, the page shows the IP address along with other details.

Note: If it is set on DHCP mode the IP address will constantly change.
The IP address is assigned automatically by your router using a protocol called DHCP.

Hope it helps.

Sandeep Kumar M

Microsoft Community – Moderator

 

RDP Not working with port 3389

So I have a tp-link router and I port forwarded port 3389 to my ip address. I port forwarded the ipv4 found in network and sharing center. I checked to see if the port was open at canyouseeme.org but it said the port was closed and I was not able to change
the ip it was looking for to the one in network and sharing center. I opened port 3389 in Kaspersky and enabled RDP in Windows Firewall.

Anyone have any suggestions?

 

How to list the ICS clients' IP addresses in Windows 10?

Hello,
I'm using ICS on Windows 10 (has both WiFi and Ethernet) to share Internet with other Windows 10 machines (on Ethernet) and is working perfectly fine. The Server is getting assigned 192.168.137.1 IP and the clients are getting IP's in the same subnet but with random IP addresses. I would like to know from the ICS server about the list IPs assigned to the ICS clients so that I can communicate with clients with IP. I don't have monitors connected to the clients, I access them vi RDP.

Please advise if it is possible to know the clients' assigned IPs (ofcourse, i can run a script with ping to each IP in the sequence to find out which IPs are UP but I don't want to do that way) from ICS server. If NOT then is there any easy free alternative to ICS?

Thanks