Windows 10: How to know if Bit locker Encrypted entire Drives

I encrypted three drives a long time ago. One SSD drive and two regular hard drives. I don't remember if I encrypted the entire drives or not. I want to make sure I encrypted the entire drives instead of just only encrypting the data that was used. How do I find this information out? Thank you.

:)

 

Bit locker Encryption

Hello Fiends,

Actually my problem is that i have previously installed windows 7 ultimate(32 bit) in my desktop and to protect my data,
encrypted the "D drive" using bit locker, then after few months, i installed
windows 10 pro(64 bit) in my desktop without disabling the bit locker, after installation i was able to access my locked drive with same password.

Till here everything was fine, but after some days my Desktop started to lag then again i switched to
windows 7 ultimate(64 bit).

But Now i'm not able to access my encrypted drive which was locked by bit locker with same password.

While i'm trying to unlock the encrypted drive i'm getting the massage as
"Unable to Complete the requested operation because of either a catastrophic media failure
or a data structure corruption on the disk".

Pls Help.

Thanks.

 

cant open my bit locker encrypted drive

after installing updates of windows 10. i cant open my bit locker encrypted drive. an pop up error appears "parameter not found". please help me solve this issue

 

Windows 10: How to hardware encrypt using bit locker without TPM.

Hi Ajit,

I realize the inconvenience you are experiencing with encrypting the hard drive on Windows 10.

This issue might be due to problems with change in group policy settings for bit locker.

To assist you better, please provide us the below information:

• Have you created any system restore point on the computer prior to the issue?

I suggest you to manage the bit locker settings in the group policy settings by following the below link and check if it helps.

First before performing any changes in Bit locker settings, I suggest you to create System Restore point on the computer. So that we can restore back to previous Windows state if any issues occurs.

http://windows.microsoft.com/en-us/windows-10/create-a-system-restore-point

I suggest you to refer to the below Microsoft Help Article about managing bit locker settings in the Group policy settings and check if it helps.

http://windows.microsoft.com/en-GB/windows7/What-Group-Policy-settings-are-used-with-BitLocker

Reply to us with the information, so that we can assist you better.

Please get back to us with an update on bit locker issue, we will be happy to help.

Thank you.