Windows 10: How yo factory reset my pc in my lock screen?

I need help trying to reset my pc i tried installing tiny 11 but i seem to installed it the wrong way now im stuck in my computer with no advance boot option so i coulndt factory reset it and i have no network on safe mode Please help.

:)

 

unable to scroll lock screen after update htc mozart

If you can not slide the lock screen it may well be an issue with the digitizer.

The only other suggestion I have is perform a hard reset to return the device back to factory defaults. If that does not work, you will have to send it in for repair/replacement sushi21.

Steps to hard reset using phone buttons:

• With the phone turned off, press and hold the VOLUME UP and DOWN buttons, and then briefly press the POWER button.
• Wait for the screen to show the instructions on how to do the factory reset, and then release the VOLUME UP and DOWN buttons.
• Follow the instructions onscreen to factory reset your phone.

 

How to factory reset Cisco 1700 Router

Hopefully I can help you here....its a very common thing to happen.


First, I take it you dont know the passwords for console access or telnet/ssh?

I will assume that these devices belong to you.

step 1. Plug a cisco console cable into a serial port on your pc
step 2. Plug other end into Cisco console port
step 3. Using hyperterm or putty or similar connect to the serial port
step 4. boot router, and make sure you clearly can see the output (this confirms you have good serial comms)
step 5. if this fails, adjust the comm port settings (9600, 8,1,n are the default)
step 6. now you have to do the only hard part...send the break command:

Break command list: Break Commands

Go down the list and match your OS and SW and try the sequence suggested.

If this fails several times do what I do: Install putty (free) and then to send a break so you can get into rommom just hit "ctrl-a b".

 

PC Build Steps

Ok just because I like steps i am going to create some steps. Please give me the stamp of approval/disapproval

• Install system in case
  • Remember to connect SSD and optical to same SATA ports on motherboard
• Turn on PC
• setup HDD
• run blend test in prime95 for 30-60 min
  • run realtemp at the same time

• While in Prime95 test
  • if CPU goes above 70c in RealTemp, I have a leaky CPU
  • if my system locks up or blue screens, there is an instability in the system somewhere
  • if my system does not lock up or blue screen, my CPU is not damaged and I am in the clear!

What do you guys think??